Expert Answers about GMC Safari
- Mounting Bolt Size of Draw-Tite Hitch for 2005 Chevy Astro or GMC Safari
- Thank you for your purchase of the Draw-Tite Trailer Hitch Receiver # 75122 for your GMC Safari or Chevy Astro.
The bolts that come with the hitch are M10 x 1.50 x 35mm hex bolts. I have added a link for you to check out as well of the instructions of the Draw-Tite Trailer Hitch Receiver # 75122.
view full answer... - How to Install a Brake Controller in a 2003 GMC Safari
- You will need to start with a 4-way (if you do not have one) on your 2003 GMC Safari. For that you would want the # C55411.
From there you would need to convert the 4-way to a 7-way so that you can install the brake controller. For that you will want the Brake Controller Install Kit and 7-Way Adapter part # ETBC7. I attached installation instructions and an install video for this product as well.
For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This...
view full answer... - Installing a Brake Controller from Scratch on a 2000 GMC Safari Van
- In order to install the Prodigy P2 brake controller, # 90885, you will need to hardwire it using a 4 and 7 Way Installation Kit, # ETBC7. If you do not have a 4-Way already on your 2000 GMC Safari, you will need to install one first. You will need Draw-Tite Wiring, # 18252. This is a basic hardwire harness. Yellow is for left turn and brake, brown is for running lights, green is for right turn and brake, and white is the ground. I have included a video showing how this harness is installed.
With...
view full answer... - What Wiring is Required to Install an Electric Trailer Brake Controller on a 2002 GMC Safari Van
- In order to install the Tekonsha Prodigy P2 Brake Controller, # 90885, on your 2002 GMC Safari, there are a couple of items you will need in addition to the brake controller. If the van does not already have a 4-Way trailer connector, you will need to add one using 4-Pole Hardwire Kit Including Circuit Tester, # 18252. I have included a link to a video showing a typical installation.
With the 4-Way installed, you would then need to add a 4 and 7 Way Installation Kit, # ETBC7. This kit...
view full answer... - Brake Controller Wiring on a 1994 GMC Safari
- The best bet would be to locate the stoplight switch at the top of the brake pedal, and then locate the wires or wiring harness that comes from it. Using a circuit tester, like part # PTW2993, probe the wires until you find one that shows a signal only when the brake pedal is applied.
view full answer... - Trailer Brake Controller Installation in 2003 GMC Safari Van
- The installation of a trailer brake controller like the Prodigy P2 # 90885 in a 2003 GMC Safari van and the parts needed will depend on how it is equipped.
If the van has a factory-installed 7-way trailer connector you may be able to find a pre-installed blue wire (for the controller's output signal to the 7-way) that will be under the dash near the emergency brake pedal. This will connect to the controller's blue wire.
If your truck has a round plug with a cap inside the driver's side...
view full answer... - How Would the Engager Trailer BreakAway Kit # 20099 Install on a Trailer
- It would be pretty straightforward. You would want to remove your current breakaway system and install an Engager Trailer BreakAway Kit # 20099 like you referenced. To see how it would install I attached installation instructions, and install video, plus an FAQ article on these systems.
view full answer...
Go To Results