A high low adapter that would work for your 2006 Toyota Avalon with a 1-1/4 inch receiver and be a compatible fit with your cargo carrier would be the Brophy Hitch Adapter # HT5R. This will work in a 1-1/4 inch receiver and the adapter is a 2 inch receiver opening. This adapter is designed to work with both Class I or Class II hitches. The item that you referenced is intended to be used with a 2 inch receiver hitch.
After conducting some research it looks like your 2006 Toyota Avalon... view full answer...
To add a 4-way wiring harness to your 2008 Toyota Avalon you are going to want the Tekonsha Upgraded Circuit Protected Tail Light Converter Hardwire Kit w/ 4-Pole Connector item # 119178KIT. I have linked an installation video below. view full answer...
On the CURT Class I 1-1/4 Inch Hitch, part # C11427, for the 2011 Toyota Avalon, the crossbar is under the bumper but underneath the car. The receiver portion is the most visible part of the hitch you will see.
I do not have a picture of the CURT hitch on a 2011 Toyota Avalon, but I am including a link to the instructions on the Draw-Tite Class I 1-1/4 Inch Hitch, part # 24870. The instructions for the Draw-Tite hitch will show a side view drawing of how the hitch will be located on the... view full answer...
The online manual for the 2017 Toyota Avalon says tire chains can be used on the front tires and up to speeds of 30-mph. The 17-inch tire size that comes on the car is 215/55-17 and for this tire size we have chains that are shown on the linked page. You might want to check your printed manual just in case it differs from the online edition.
The best chains for this tire size are the Konig Low-Pro Snow Tire Chains # TH04115100. I recommend these chains because they include important features... view full answer...
The Konig CG9 # TH00023100 and the XG12 # TH2004705227 are very similar in that they both have the same easy install and high quality materials so they last long, but the big difference is that the XG12 has ice breaker plates that run down the center of the tire which give the tire setup more traction in deeper snow and also break up ice a bit better as well. view full answer...
Yes, the Jensen RV Stereo # JWM60A will replace your Memorex CDR-1000 although you might need to make the cutout a little larger (see attached image).
The JWM60A and JWM62A are the exact same model with the only difference being where it's manufactured. Our part number is the 62 model even though our listed part number doesn't reflect that.
Hope this helps you out! view full answer...
As long as the motorcycle trailer doesn't weigh more than 2000 lbs fully loaded and have a tongue weight greater than 200 lbs, the Curt Class I hitch, part # C11427 would work just fine for a motorcycle trailer.
In order to complete your towing setup, you'll need a trailer wiring harness like # 119178KIT, a ball mount like part # C45022 and a # PC2 hitch pin and a 1-7/8 hitch ball like # A-80 or a 2 inch ball like # A-82 view full answer...
If your Dometic Penguin has either a 6-pin or 9-pin connector you can replace the rooftop unit without having to replace the air distribution box or thermostat. If you remove the cover for your air distribution box then you should be able to see the controller and the wire harness that runs from the rooftop unit down to it to see what type of connector it has. If it has a 6-pin connector then you would just need the rooftop unit, if it has a 9-pin connector then it would need an adapter... view full answer...
I would be happy to help you again. The only hitch available for your 2007 Toyota Avalon is going to be the Curt Trailer Hitch item # C94UR. This hitch is custom fit and bolts to your Toyota with included hardware.
This is a class I hitch with a 1-1/4" receiver. It has a 2,000 lbs towing capacity, and a 200 lbs maximum tongue weight.
You are going to be extremely limited in options for a bike rack since your hitch is only a class I. The best one is going to be the Thule EasyFold XT Bike... view full answer...
We have a little more freedom in the information that we share so for your 2013 Toyota Avalon the Yakima FullBack 3 Bike Rack # Y02633 will physically fit, yes. But if you look at the installation notes in the fitguide system it says "Maximum load is 2 bikes due to vehicle construction". So the 3-bike version fits but you should only be carrying 2 bikes in those front 2 cradles regardless.
If it makes you feel better just pick up the 2-bike version, part # Y02634, instead. This has the... view full answer...
There is a hitch that will fit your 2016 Toyota Avalon Hybrid, the Draw-Tite # 36540, which is a Class II hitch with a 1-1/4" receiver; I checked with Draw-TIte to confirm this. Keep in mind you will need a bike rack which fits in a 1-1/4" receiver and is Class II compatible such as the Kuat Transfer # KU74FR.
I've added a link to our selection of our bike racks that have a 1-1/4" shank for you to check out or if you let me what type of rack you are looking for I'd be happy to make a recommendation... view full answer...
The Thule Passage 2 Bike Carrier, part # TH910XT, is confirmed to be a fit for your 2014 Toyota Avalon.
This carrier uses a patented FitDial system that helps make sure the carrier fits your Avalon and has cushioned anti-sway cradles.
If you are planning on carrying any bikes with alternative frames like kids bikes or women's bikes, I recommend an adapter bar like part # 64005. This attaches between the seat post and the handlebar stem and allows the bike to ride more level while providing... view full answer...
The Saris Freedom 2 Bike Platform Rack part # SA4412B would be a perfect option for a Specialized Turbo Vado 4.0 E-Bike. The tire size, fenders, weight, rear rack, and frame construction should not be a problem. I however recommend using the frame clamps to secure the bike by the horizontal top tube. view full answer...
As long as you have enough bar space and sufficient weight carrying capacity on your roof rack and vehicle, there isn't any reason why you can't carry a surfboard and bike at the same time. A Rhino-Rack roof rack system that uses the # RRVA126S-2 crossbars, # RRRLKVA legs and # DK361 fit kit will have 49" long cross bars- which can fit more than one accessory at a time as long as they both fit within the constraints of the bars.
The Rhino-Rack SUP and Surfboard Pad # RRRWP04 is 27-1/2"... view full answer...
Yes, the Thule OutWay 2 Bike Carrier, item # TH45JV, will fit the 2008 Toyota Avalon. Be aware that the bumper cover may deform with the use of this carrier. If you remove carrier when not in use this will greatly reduce the chance of the bumper staying in the deformed position.
Another option for your Avalon is a receiver hitch and a hitch mounted bike rack. The Curt Class I Receiver Hitch, item # C11427, will work nicely with a 1-1/4 inch Class I bike rack such as our Thule Camber, item... view full answer...
The Kat's Heaters Lower Radiator Hose Heater # KH16400 is a universal fit and will work with your 2007 Toyota Avalon so long as your lower radiator hose is 1" diameter. If you have a 1-1/4" diameter lower radiator hose you would need # KH16500. It will maintain up to a 270 degree temperature which means your Avalon will heat up much, much faster.
The Kat's Heaters Thermal Battery Wrap # KH22200 will work with an Avalon so long as it has a Series 24, 24F, 27, 27F, or 74 automotive battery.... view full answer...
Yes, we actually have a two 2-bike trunk mounted racks that have been confirmed to fit both the 2015 Subaru Outback and the 2013 Toyota Avalon.
We have the Thule OutWay, # TH45JV or the Thule Passage, # TH910XT.
My personal favorite is the Thule OutWay 2-Bike Rack, # TH45JV. What makes this rack far superior to the others is the attachment system. It uses only 2 retractable coated steel cables to attach to the vehicle rather than six nylon straps like most other racks. This makes installation... view full answer...
The Curt # C13701 trailer hitch that you referenced is intended for RVs and Camper Trailers; it is not compatible with your 2008 Toyota Avalon.
For your Avalon you will need to go with a custom fit option that was designed to work with your specific vehicle. The Curt # C11427 is what you will want to go with instead. It is a Class I hitch with a 1-1/4 inch receiver. You could try using an adapter like the Brophy part # HTAD, but it will reduce the tongue weight capacity by 50% and increase... view full answer...
The least noticeable trailer hitch we offer for your 2003 Toyota Avalon XLS is the Draw-Tite # 36293.
This Class II trailer hitch has a towing capacity of 300lbs tongue weight and 3,500lbs towing weight. You will want to be sure that your vehicle is capable of supporting this type of weight, just because the hitch is designed to doesn't mean the vehicle can, be sure to check your owners manual.
Some other items you will need to tow a small trailer are a ball mount and a ball like # 36051... view full answer...
It all depends on what Yakima equipment you already have to determine whether the components will work on our 2016 Toyota Avalon. You clearly want to use as much that you already have and not have to purchase anymore than you need.
There are a number of Yakima roof rack systems compatible with your 2016 Toyota Avalon. The towers that are specific to your car are the Yakima Baseline Towers # Y28TR and the BaseClips # Y06130 and Y06131. They will fit your car, it's just a matter of whether... view full answer...
Go To Results