bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Subaru WRX


  • Recommended Hitch for a 2022 Subaru WRX
  • I checked with Draw-Tite and I am happy to confirm that the Draw-Tite Trailer Hitch item # 76271 does fit the 2022 Subaru WRX. This hitch is custom fit and bolts to your Subaru with included hardware. I have attached a link below to the instructions for the Draw-Tite item # 76271. It shows the different steps needed to add this hitch to the WRX along with the Forester. If you are planning on towing you will also need a wiring harness item # 119250KIT and a ball mount kit item # C45534.
    view full answer...

  • What Does EcoHitch part # 306-X7257 Weigh
  • The EcoHitch part # 306-X7257 that you referenced weighs 36 lbs.
    view full answer...

  • Distance From Hitch Opening of EcoHitch to Bumper for 2016 Subaru WRX
  • I spoke with my contact at EcoHitch and they sent me this in response to your question: "For the measurement from the end of the receiver to the end of the bumper, I don't have that info handy but based on photos of installation, I would assume it would be right around 1-2" before being exposed. The distance from the pin hole to the edge of the receiver, the measurement is 1"."
    view full answer...

  • Towing Capacity of EcoHitch Trailer Hitch Receiver on 2017 Subaru WRX STI Limited
  • The EcoHitch Invisi Trailer Hitch Receiver - Custom Fit - Class III - 2" # 306-X7257 is a great fit for your 2017 Subaru WRX STI Limited. It is rated for towing up to 3,500 lbs but Subaru does not recommend towing with your vehicle according to the owner's manual. Many customers have chosen to tow small trailers anyway and we have not heard of issues but it would be at your own risk. If you decide to tow your 16 foot jon boat with this vehicle, you will need the Curt T-Connector Vehicle...
    view full answer...

  • Recommended Hitch for a 2022 Subaru WRX
  • I would be happy to help. I checked with our vendors and the only hitch available for a 2022 Subaru WRX is the Draw-Tite Hitch item # 76271. This hitch is custom fit and bolts to your Subaru with included hardware. If splicing is a no go for you, I recommend the ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector item # 119250KIT. This is also a universal wiring harness but it uses clamps to receive the signal from your wires without cutting into them. To round...
    view full answer...

  • Center of Pin Hole to Near End of Shank on Thule T2 Classic Bike Rack
  • I did some calculations and determined that from the center of the hitch pin hole to the nearest end of the shank is approximately 1-1/2 inches for the Thule T2 Classic # TH9045. I have linked a video review of this bike rack for you.
    view full answer...

  • Do I Use Hitch Tongue Weight Capacity or Vehicle Tongue Weight Capacity
  • When it comes to towing, you are always going to be bound by the component with the lowest capacity so even though the hitch can handle more weight, your vehicle can not. Since you mention that the tongue weight capacity of your vehicle is 165 lbs, a 280 lb power chair would exceed the tongue weight capacity and could cause damage to your vehicle but I do have a solution. The best solution would be to buy a lightweight trailer to transport your power chair. The hitch that we offer for...
    view full answer...

  • Receiver Depth on EcoHitch Invisi Trailer Hitch Receiver # 306-X7257
  • I went out to our warehouse to take a look at the EcoHitch Class III Trailer Hitch # 306-X7257 referenced in your question, which is confirmed to fit your 2015 Subaru WRX. The receiver is actually hollow but from front to back it measures exactly 4 inches. I have attached an image to assist.
    view full answer...