You can absolutely adapt a set of Thule crossbars to your 2013 Toyota Venza. I recommend checking out the Thule WingBar Evo Crossbars # TH711220 with the Evo Raised Rail Feet for Thule Crossbars # TH710401.
These Thule crossbars will work great with your factory rails, measure 47" long, and has a 220 lb dynamic weight capacity. These crossbars also have an integrated top channel so you can easily mount roof accessories to your bars. view full answer...
What you're seeing is the Shark fin style camera mount for a Furrion Vision S system like the # FOS05TASF but it looks like the camera was removed. You can install a new Furrion system by plugging the new camera to the existing wire and attaching to the bracket that you're seeing. view full answer...
Draw-Tite trailer hitch # 75663 for the 2010 Toyota Venza uses M10-1.25 x 40mm CL 10.9 Hex Bolts, 3/8” Conical toothed Washers, and 5/16” x 1” x 1-1/2” Block-Spacer, ( AWD vehicles only).
If you have the hitch but not the hardware order # RHK. Enter the hitch number and manufacturer on that page to get the right hardware.
If you have the hardware but it is not going in easily then the weldnuts will need to be cleaned. I have included some links that show and explain this for you. view full answer...
Out of all the trailer hitches that are confirmed to fit your 2022 Toyota Venza I recommend the etrailer Trailer Hitch Receiver # e25AR. I like the etrailer hitch better than the other hitches that we offer because the etrailer hitch has a matte black coating that will help hide scratches and scuffs better that are caused by rocks and flying debris when hauling your bikes around. The other hitches have a gloss black coating that makes the scratches and scuffs more visible.
When it comes... view full answer...
Motorcycles and trailers made for motorcycles have separate brake lights and turn signals. Trailer wiring harnesses for vehicles combine the brake and turn signals onto the same circuit. That is why there is a discrepancy.
You will essentially have to make an adapter starting with wiring harness # 118482. On the output side cut off the 4-Way connector. You will need to hardwire the wires to another converter, # 118158. The brown wire will bypass the second converter. Then on the output... view full answer...
Though you can not replace the module only on your wiring harness on your 2013 Toyota Venza, I do recommend replacing the harness with The Curt T-Connector Vehicle Wiring Harness # C56079.
This harness will plug into your vehicle's wiring harness, which is located behind the driver's-side and passenger's-side interior trim panels in your rear cargo area.
I attached an installation video link below. view full answer...
A Class III ball mount is a great option for you with the Class III trailer hitch installed on your 2013 Toyota Venza. Since your boat trailer has a 2 inch coupler, you will certainly want a hitch ball that has a 2 inch diameter ball in order to seat the coupler properly.
Another thing to consider when choosing a ball mount is the height of the hitch receiver and the height of the trailer coupler. You will want to choose a ball mount that will allow you to tow the trailer level. The... view full answer...
Go To Results