Expert Answers about Kenworth T600

• Timbren Suspension Enhancement System for 1994 Kenworth T600
• We have the Timbren Suspension Enhancement System item # TKWRAG100 and it is a confirmed fit for you 1994 Kenworth T600. However, the kit comes with 4 bump stops and brackets. They do not offer a two bracket kit that fits your Kenworth.
  view full answer...


• Replacement Brake Assemblies for Dexter 10k Trailer Axle
• Yes, for your Dexter 10k axles you can use the 10k brake assemblies part # AKEBRK-10R and # AKEBRK-10L that you mentioned. These were designed for your Dexter 10k axles and the slight narrower width would not be an issue at all.
  view full answer...


• Recommended Circulating Coolant Tank Heater for a 2005 Kenworth T600 with Cummins ISX Engine
• I have exactly what you will need to ensure warm coolant in flowing through your 2005 Kenworth T600 at all times. For this you are indeed going to want a large capacity coolant heater. The most well equipped heater we have for your needs is the Kat's Heaters Thermostatically Controlled Circulating Tank Heater part # KH13200. The heater is thermostatically controlled meaning it turns on when plugged in and shuts off when the temperature reaches 175 degrees fahrenheit. The above heater is...
  view full answer...


• How To Wire a Semi to Tow an RV
• The brake and turn signal circuits are combined in standard trailer wiring applications therefore, I think there might be an issue with how the tow vehicle is wired. If the tow vehicle uses separate brake and turn signal circuits then you will need to combine them with the Roadmaster Brite-Lite Wiring Converter part # RM-732 which can then be wired to the 7-Pole and 4-Pole Trailer Connector Sockets w/ Mounting Bracket part # HM40975-11998. If you can't access the stop light circuit on your...
  view full answer...


• What are the Wire Functions for Vision X Headlight Conversion Kit # VX-46
• On the Vision X Headlight Conversion Kit # VX-46 the black wire is the ground. From what I understand the white wire is low beam and the red wire is high beams. Since they take 9007 bulbs though it shouldn't matter because one wire energizes a filament for low beams and the other energizes a filament for high beams. So basically you could switch them and they would still function.
  view full answer...