What are the Wire Functions for Vision X Headlight Conversion Kit # VX-46
Question:
Have 1996 Kenworth with four sealbeam headlamp looking at your conversion kit but the kit dont say if one light is low and one is high been or both low for the wires
asked by: Randy
0
Expert Reply:
On the Vision X Headlight Conversion Kit # VX-46 the black wire is the ground. From what I understand the white wire is low beam and the red wire is high beams. Since they take 9007 bulbs though it shouldn't matter because one wire energizes a filament for low beams and the other energizes a filament for high beams. So basically you could switch them and they would still function.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Vision X Headlight Conversion Kit - Sealed Beam to Halogen - 4" x 6" Rectangle
- Vehicle Lights
- Headlight
- Pair of Lights
- Halogen Light
- Light Assembly
- Rectangle
- White
- Vision X
more information >
Continue Researching
- Q&A: Is the Vision X Headlight Conversion Kit # VX-46 Sold in Pairs or Individually
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Installation Instructions for Breakaway Kit Part # 50-85-313 and Trailer Wiring Junction Box # 38656
- Q&A: Replacement LED Flood Light for Load Lights on a Horse Trailer
- Q&A: Interior and Exterior Horse Trailer Light Recommendations
- Q&A: Finding the Stop Light Switch Wire for Installing a Brake Controller on a 1995 Chevy C/K Pickup
- Q&A: Replacement Front and Rear Sway Bars for 2015 Thor Axis 25.1
- Q&A: Brake Controller Install on 1995 Chevy C Series Pickup Truck
- Article: Stability Control for Heavy Duty Vehicles
- Article: Replacement Automotive Lighting
- Article: Performance Chips and Modules