For your 2005 Acura RL you want to select the correct transmission cooler by determining where there is enough space to mount it. If after measuring you find you have enough space, the cooler you referenced, part # D13613, would work well for you. I have attached a drawing that shows 3 positions for mounting transmission coolers. Transmission coolers are much more efficient when they are positioned to receive maximum air flow. At position 1, the transmission cooler is 100 percent efficient.... view full answer...
We do have a few wiring harnesses that are confirmed to fit your 2011 Acura RL, but they are all universal fit options.
Out of the linked selection I recommend going with the 4-Pole Trailer Connector and Installation Kit # C59496 as we have found to be one our most reliable wiring manufacturers.
As far as an installation video goes, we actually shoot our own when we can. I have linked a sample installation video of this kit on this answer page for you to check out. It isn't on an Acura... view full answer...
The installation of the Draw-Tite Class I Receiver, part # 36226 on your 1998 Acura is fairly simple. The exhaust is temporarily removed from its hangers, and then the tow hook is removed. The hitch is initially held in place using the provided hardware using the hole where the tow hook was attached. Then, after making sure that the hitch is centered on the vehicle frame, the hitch is used as a template fro drilling the three remaining holes. The remaining three bolts and block washers... view full answer...
We have the perfect trailer hitch that is confirmed to fit your 2006 Acura RL!
We are not running any promotions for any products on our site at this time or in the foreseeable future. The trailer hitch has a bolt-on installation with no welding required. It has a gloss black powder coated finish that is over a protective base coat that offers a superior rust resistance.
The trailer hitch has a maximum gross trailer weight up to 2,000 pounds and has a maximum tongue weight up to 200... view full answer...
Sorry to hear your system broke and there aren't replacement parts available for your horse trailer.
The Bulldog Velocity Series Electric Landing Gear Jack - 24" Lift - 12,000 lbs # BD185400 is a good replacement for your discontinued and broken system. It will simply bolt right on to your trailer so it can utilize the 12V power you already have run. It is able to lift 12,000 lbs and lifts 20 inches in 60 seconds.
Another great option for you is the Bulldog Square Jack - Drop Leg w/... view full answer...
Yes, the Thule K-Summit Tire Chains part # TH02230K44 that you referenced will fit the tire size 245/45-18 that you have and that you sent in a picture of.
These chains are great because they don't drape over the inside corner of the tire so they do not require any amount of inner tire clearance and they don't touch the rim so you don't have to worry about them damaging the nice finish of your wheels.
For an all wheel drive vehicle ideally you would put chains on all four wheels as that... view full answer...
Your Curt Class I Hitch, part # C11336 is rated for a tongue capacity of 200 pounds and has a 1-1/4 inch opening. The most important part about the Class I hitch is that they are built to only carry weight within a particular distance behind your vehicle. This limits the range of carriers that you can use on your vehicle. You should always verify your tongue weight with your owner's manual prior to loading cargo on the trailer hitch attachment of the vehicle.
I recommend the 20x47 Reese... view full answer...
Go To Results