bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Nissan Murano


  • Best Towing Setup for a 2016 Nissan Murano
  • Your 2016 Nissan Murano did not come from the factory with a trailer wiring harness therefore if you will be towing a trailer you will need one and for this I recommend the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part # 118660 which is a complete plug and play kit that will not require you to cut or splice any wires. We also have an install video of this hitch on a 2016 Nissan Murano which I have attached for you. This install will be even easier than a trailer hitch....
    view full answer...

  • Will Swagman Quad 2+2 Bike Rack # S64FR Fit on a 2010 Nissan Murano
  • Providing your 2010 Nissan Murano has a trailer hitch with a 2 inch receiver opening, the Swagman Quad 2+2 Bike Rack # S64FR that you referenced should fit. To ensure this fit, one simple measurement is needed. Measure from the center of your hitch pin hole to the outermost edge of your bumper. If your measurement is less than 9 inches then this bike rack will be able to fold up against your Murano when it is not in use. In the hitch installations that we have done on Muranos we have...
    view full answer...

  • Will Thule Passage 3 Bike Carrier - Trunk Mount, # TH911XT Fit a 2010 Nissan Murano S
  • According to Thule, the Thule Passage 3 Bike Carrier - Trunk Mount, # TH911XT, will fit your 2010 Nissan Murano. You may also be interested in add the Alternative Frame Bike Adapter Bar for Hitch Bike Racks, # TH982XT, for bikes that do not have a top frame bar that is parallel with the ground. I have included a link to a video review of this adapter below.
    view full answer...

  • Is There a Wiring Harness That Will Work With My 2014 Nissan Murano CrossCabriolet?
  • You are correct, the Curt Hitch # 13577 is a fit for your 2014 Nissan Murano CrossCabriolet and the installation is relatively simple. And, we do have a wiring harness that will work for your vehicle, but it will have to be hard-wired. Don't let that scare you, we have detailed instructions and a video of the installation on a Nissan. A popular wiring kit for the CrossCabriolet is Curt # C56496. I would also recommend purchasing Dielectric Grease, # 11755, for the electrical connectors...
    view full answer...

  • Compatibility of Prorack 3 Trunk Mount Bike Rack with 2007 Nissan Murano
  • The Thule # TH910XT Passage Trunk Mounted Bike Rack is indeed a fit for your 2007 Nissan Murano. If you'll be transporting women's bikes or bikes with sharply-angled top tubes, you might also consider a frame adapter bar like part # 64005. The bar spans the distance between the handlebar gooseneck and the seat post, which provides a secondary attachment point for the bike rack. This allows the bike to be carried level, which maximizes ground clearance. I'll link you to a video showing...
    view full answer...

  • Will the Thule Passage Trunk Mount Bike Rack Fit on a 2011 Nissan Murano
  • Yes, the Thule Passage, # TH910XT, is recommended for use on your 2011 Nissan Murano as long as it is not a CrossCabriolet model. This is a good quality rack that will work well for you. I added a link to all of the trunk mount bike racks that will fit on the 2011 Murano. Another rack you might want to consider for ease of installation and removal is the Thule OutWay 2 Bike Carrier, # TH45JV, which also fits the your vehicle. You may also need the Thule Bike Adapter, # TH982XT, which...
    view full answer...

  • Will Henninger Hitch Lock HE6033 Fit a SportRack Bike Rack SR2703
  • Generally speaking bike rack manufacturers thread their hitch bolts uniquely so as to only work with their bike racks. That coupled with the fact that the bike rack, # SR2703, and the lock, # HE6033, have not been tested together leads me to recommend going with the SportRack lock # SR0901
    view full answer...

  • Will the Yakima SkyBox NX 16, part # Y95AV, Cargo Box Work on My 2009 Nissan Murano
  • Yes, the Yakima SkyBox NX 16 Cargo Box, part # Y95AV, has been confirmed by Yakima to fit on the factory cross bars of a 2009 Nissan Murano. If positioned correctly on your roof you should not have to worry about your trunk interfering with this box, the angle of the back of the box also helps give you a little more clearance for when your trunk is opened. You can confirm this fit by measuring from the center of the front crossbar back to the line where the hatch meets the roof. If this...
    view full answer...

  • Fitting the Swagman XC-2 Bike Rack to a 2015 Nissan Murano
  • The Swagman XC-2 rack, part # S64650 will work with your 2015 Nissan Murano as long as its equipped with a trailer hitch, either a 2 inch or 1-1/4 inch hitch. I've attached a video of this rack being installed on a 2014 Nissan Murano so you can see how it sits on the vehicle and behaves on our test course. This rack doesn't include a hitch or bike lock, so you'll want to add them to the bike rack with the hitch and cable lock kit, part # S64031. This will let you use the hitch as a locking...
    view full answer...

  • Will Thule Force XT Sport Cargo Box Fit a Malone AirFlow2 Roof Rack on a 2014 Nissan Murano
  • Yes, Thule Force XT Sport Rooftop Cargo Box Item # TH6356B fits the Malone AirFlow2 Universal Roof Rack for Raised Side Rails # MPG215 for your 2014 Nissan Murano.
    view full answer...

  • Will Curt Trailer Hitch 13571 Fit a UK Spec 2005 Nissan Murano
  • The trailer hitches we carry are designed for the US spec market vehicles. However, it may be possible for the Curt trailer hitch # 13571 to fit. You will need to look at the linked videos and the instructions to see where the hitch installs and compare that to your 2005 Nissan Murano. If the vehicle is the same where it counts for hitch installation then you can install it. If it is different you might want to take a look at Bosal hitches. If the Curt hitch will fit then to complete...
    view full answer...

  • Trailer Hitch and Bike Rack Recommendations for a 2018 Nissan Murano
  • Out of the Curt # C13205 and Draw-Tite # 75952 trailer hitches for your 2018 Nissan Murano I recommend going with the Draw-Tite. Reason being that the Curt requires a stabilizing strap like part # 18050 for all non-trailer loads, like a bike rack, to remain under warranty whereas the Draw-Tite does not. The installation is actually very easy and you shouldn't need a lift for it. If you check out the linked installation video, we didn't even have to lower the exhaust on a 2017 model. The...
    view full answer...

  • Can Weight Distribution be Used with a Draw-Tite 75148 on a 2007 Murano
  • The Draw-Tite # 75148 is designed for standard towing only and cannot be used with weight distribution, unfortunately. With that being said, if you can find a camper with a lighter tongue weight, you would be fine to tow with a standard ball mount. If you do end up going with a lighter camper, you can add on the Reese Sway-Control Bracket for 2" Ball Mounts # RP26003 and Curt Friction Sway Control # 17200 for a sway control option if needed. If you also experience squatting, I do suggest...
    view full answer...

  • Will the Thule Roadway 4 Bike Carrier Fit 2009 Nissan Murano and Carry Children and Adult Bikes
  • Thule Hitching Post Pro 4 Bike Carrier, part # TH934XTR, will fit both Class I and II, 1-1/4 or 2 hitches. If you have a Class I, 1-1/4 inch hitch you will only be able to carry 2 bikes on this rack. You will want to check your hitch to make sure you do not exceed the tongue weight capacity when carrying the bike rack and bikes. The Thule Hitching Post Pro 4 Bike Carrier, part # TH934XTR, will work with your 2009 Nissan Murano in a 1-1/4 or 2 hitch. This bike rack has anti-sway cradles...
    view full answer...

  • Can I Attach A Thule Hullavator Pro To My 2012 Nissan Murano With A Factory Rack
  • Yes, you can install a Thule Hullavator to your 2012 Nissan Murano with a factory rack. However, you cannot attach it to your vehicle's OEM factory crossbars. Your crossbars must extend between 4" and 8" beyond the towers in order to attach a Thule Hullavator Pro. This is why the Hullavator Pro is not compatible with factory roof racks, their crossbars terminate at the towers. You will have to install an aftermarket roof rack in order for you to be able to install the Thule Hullavator Pro...
    view full answer...

  • Trailer Hitch Receiver Recommendation For 2018 Nissan Murano
  • There is a trailer hitch receiver that fits your 2018 Nissan Murano, and the best option for a fit is from Draw-Tite: - Draw-Tite Max-Frame Trailer Hitch Receiver # 75952 There are a couple reasons the Draw-Tite # 75952 is the best option for your '18 Murano, starting with the fact it has the best bumper and ground clearances so it will be easier to use for either a ball mount or accessory so you don't have to reach so far back under the vehicle. It will also help keep accessories like...
    view full answer...

  • Can Thule Tram Ski and Snowboard Carrier Adapter Work With Thule Hitching Post Pro Bike Carrier
  • The Thule Tram Ski and Snowboard Carrier Adapter, part # TH9033 will work great with the Thule Hitching Post Pro, part # TH934XTR. The # TH9033 secures to the Hitching Post with the cradles and straps and the nice thing is it comes with two One-key locks to keep the skis and boards secure in the rack. This carrier will hold uup to 6-pairs of skis or 4 snowboards.
    view full answer...

  • Recommended Camping Tent for Use on 2016 Nissan Murano
  • When it comes to tent occupant capacity there can be some variance between what a manufacturer thinks and what a frequent camper thinks. I know campers who use a "4-person" tent for one or two people since we people vary in size and in how much stuff we have along with us...dogs, coolers and other camping gear. The phrase "up to" is often used in tent capacity, meaning that you can just about fit 4 sleeping bags in the tent...but possibly not much else. For some folks this makes the "up...
    view full answer...

  • How to Transport a 500-LB Motorcycle with a 2020 Nissan Murano
  • I have a possible solution for you. It looks like neither your Curt Class III, part # C13205, nor your vehicle are able to support that kind of tongue weight. Your best bet is to use a motorcycle trailer which you can find online. For most of these, you will need some wiring attached to your 2020 Nissan Murano to power the lights. I recommend the Curt T-Connector, part # C56267. It includes a tail light converter to ensure that your vehicle's wiring matches the one from your motorcycle...
    view full answer...

  • Parts Needed to Add 7-Way & Brake Controller to 2014 Nissan Murano SL
  • Since you already have a 4-way like # 55571 on your 2014 Nissan Murano SL, you'll just need one part to add a 7-way: - Universal Installation Kit for Trailer Brake Controller # ETBC7 You'll plug the 4-way into the 7-way that comes with the # ETBC7, which also gives you the wiring, circuit breakers, and rest of the hardware needed for installation. After that all you need is the brake controller and harness, and for that a good option is a simple, no-frills controller, the Curt Discovery...
    view full answer...



^

Recently Viewed Products

About Us
photos and videos
1,056,204
Original Photos & Videos

Produced to make sure you know what you are getting and you get exactly what you need.

installations
35,570
Installations Completed

To make sure products work and fit the way they are supposed to.

etrailer call center
2,476,511
Phone Calls & Emails Answered

1,125,924 phone calls and 1,350,587 emails to help find the right solution.

etrailer training
400+
Average Hours of Product Training

We get to know our products firsthand so experts can better help you.

etrailer service
78
Years of Quality Customer Service

Assisting our neighbors and customers, face to face at the counter.

etrailer experts
193,357
Pages of Expert Information

Created to make sure you have all the answers to your questions, from real experts.