Expert Answers about CrossRoads

• Troubleshooting Lippert Ground Control External Sensor Error
• I spoke with my contact at Lippert and this is what they sent me about the external sensor issue you have: External sensor error means there is an issue with the rear leveling sensor. This will be located 2-3 foot behind the rearmost axle. There may be an access panel in the underbelly, or there may not. Typically this error is due to a bad connection to the sensor. It is important that once the error code has been resolved, the user of the unit must manually retract all jacks completely...
  view full answer...


• How To Install Furrion Vision S Camera System So It Works When Trailer Is Unhooked From Truck
• Yes, you would need to wire the cameras of the Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras - 5" Screen # FCE48TASL-05 differently to use them when you are not hooked up to your truck, or you would need to find a way to send power to only the running light circuit from your trailer's battery when you are hooked up to shore power. How we typically recommend you do this is running a power wire to each camera yourself and then connecting them to a switch...
  view full answer...


• Installation of Greystone Standard RV Microwave w/ Trim Kit
• The Greystone Standard RV Microwave w/ Trim Kit - 1,350 Watts - 0.9 Cu Ft - Stainless Steel, # 324-000106, or in black, # 324-000105, installs by way of setting on a shelf or in a cabinet not mounted from top such as you are describing your current arrangement. There is a trim piece that is then secured to either side using the four mounting holes located on the outside of the trim piece (see photo). This is not the of unit that is designed to be installed hanging under a cabinet or shelf...
  view full answer...


• Do Self Adjusting Trailer Brakes Require Initial Adjustment
• Self adjusting brake assemblies like the part # AKEBRK-35-SA do not require initial adjustment but you'll need to apply the brakes several times while moving slowly to allow them to self adjust to the correct tension. They will feel pretty weak at first until they reach the correct adjustment. So the easy solution for you would be to take out the trailer and while travelling slowly reach down and grab the manual override lever of the controller several times and you'll feel the brakes start...
  view full answer...


• Can a Weight Distribution Hitch Be Set Up and Used On Truck and Trailer On Driveway Hill?
• It is always best to install any Weight Distribution Hitch # EQ37100ET on flat ground to ensure you have the trailer level and bars set to the correct amount of tension. This will help you to ensure it is set correctly and will not damage the hitch. Once you know the system is set correctly on flat ground it is recommended to remove the spring bars when transitioning from the street onto a steep driveway. This is necessary to ensure the bars or L-brackets do not become damage due to the...
  view full answer...


• Can the Replacement Standard Dual Rack Repair Kit for Lippert RV In-Wall Slide-Outs Be Cut/Trimmed
• The Replacement Standard Dual Rack Repair Kit for Lippert RV In-Wall Slide-Outs part # LC84FR are cut to fit per Lippert.
  view full answer...