Expert Answers about Chrysler

• Difference Between T-one and Plug-N-Tow Trailer Wiring Connectors for a 2006 Town and Country Van
• The biggest difference between the Plug-N-Tow (TM) Vehicle Wiring Harness, item # 42235, and the Tow Ready Custom Fit Vehicle Wiring, item # 118300, is the manufacturer. The Plug-N-Tow harness is made by Hopkins and the T-One wiring harness is made by Tow Ready. Both of the Harnesses provide 4-Way, vehicle end, trailer wiring connector at the rear of the vehicle and plug inline with the vehicles tail light wiring. While the shape of the connectors may be slightly different they both are...
  view full answer...


• Comparing Fastway E2 Trunnion and Round Bar Weight Distribution Hitches
• The ground clearance difference between Fastway round bar and trunnion bar weight distribution systems is about an inch at the head so it isn't much at all. And since you need to have it set up in the rise position you could go either way and have decent ground clearance. If it were me though I would still go with the trunnion system, # FA92-00-0600, for 2 reasons. First inserting the trunnion bars into the head is easier compared to round bar systems (though neither one is all that hard...
  view full answer...


• Combination Transmission and Engine Oil Cooler for a 2006 Chrysler Town and Country
• The Derale Combination Transmission and Engine Oil Cooler, # D15902, will work for your 2006 Chrysler Town and Country. The transmission cooler does not have a specific class rating, but will be similar to our Class I rated transmission coolers. This kit is a universal fit and will install on any vehicle that has sufficient space. You will want to check and make sure there is room in front of your air conditioning condenser or radiator to install the cooler. This cooler measures 17 inches...
  view full answer...


• Comparing etrailer and Curt Trailer Hitch for 2024 Chrysler Pacifica
• The Curt # C13383 and the etrailer Trailer Hitch Receiver # e98903 are identical with the exception of the powder coat finish. They have the same bolt-on installation and the same towing capacity. The Curt has a glossy finish while the etrailer hitch has a matte finish. I prefer the matte black since it makes it look like an OEM part and also helps hide dirt and scratches. If you don't care about how the hitch looks the best choice is the one with the lower cost.
  view full answer...


• Comparing the Tekonsha Trailer Wiring Harness for 2018 Chrysler Pacifica # 118723 and # 118712
• The T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118723 is the custom fit for 2017 and 2018 Chrysler Pacifica Touring and LX models. The T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118712 is the fit for 2017 and 2018 Chrysler Pacifica (excluding hybrid), Touring L Plus, Touring L, and Limited models. The connectors are different based on the trim models but it appears the modulite is the same amperage.
  view full answer...


• Best Trailer Hitch Receiver for Bumper Clearance on 2013 Chrysler Town and Country
• The receiver with the best clearance is the Curt Trailer Hitch Receiver # 13364 which has a hitch pin hole to rear bumper length of 4". The height to the top of the receiver tube is 12-1/4" The etrailer Trailer Hitch Receiver # e98854 is a close 2nd with a hitch pin hole to rear bumper length of 4-1/2". The height to the top of the receiver tube is 13-1/4" Finally the Draw-Tite Max-Frame Trailer Hitch Receiver # 75579 has a hitch pin hole to rear bumper length of 6-1/4". The height to...
  view full answer...


• Comparing 4-Way to 5-Way Trailer Connector Adapters # 20036 and # 47515
• 4-Way to 5-Way adapters # 47515 and # 20036 are essentially the same. The difference is that # 20036 has longer wiring with it than # 47515. For that reason we normally recommend # 20036. The 4-Way to 5-Way portion is 18 inches long. The blue wire though is 60 inches long from end to end. Additional light gauge wire, such as # 16-1-1, sold in 1 foot increments could be spliced in if a longer connection is needed.
  view full answer...


• Comparing Inno Wedge 660 and Inno Shadow 16 Cargo Boxes
• The Inno Shadow 16 # INBRA1210BK has 13 cu ft of storage while the Inno Wedge 660 comes in Gloss Black # INBRM660BK or Gloss White # INBRM660WH and has 11 cu ft of storage. It may has less storage space but the Wedge 660 is actually more of a premium option due to the sleeker design of the lid and the Memory Mount hardware which is much easier to use over the U-Bolt system that comes with the Shadow 16. If you like the design and extra space of the Shadow 16 but want the Memory Mount hardware...
  view full answer...


• Difference Between Curt Wiring Harness # C56331 and Curt T-Connector Wiring Harness, # C56150
• The Curt T-Connector Vehicle Harness, # C56331 wiring harness is an updated version of the Curt Wiring Harnes # C56150. I have attached videos of the updated harness # C56331or you.
  view full answer...


• Which Trailer Hitch Finish Coating is Most Durable for a 2010 Chrysler Town and Country
• Curt produces their hitch, part # 13364 with a baked-on powder coat. Of all the finishes, I think the Curt is the most durable. However, the Curt powder coat finish is very glossy compared to the others. Some people prefer the dull finish because it attracts less attention. If this is a concern of yours, I would go with the Draw-Tite, part # 75579. It will hold almost as well as the Curt without being so glossy. My grandfather-in-law just had the Curt hitch installed on his 2010 Town and...
  view full answer...


• Compare Of Curt And Hopkins Trailer Wiring Harnesses On 2009 Chrysler PT Cruiser
• Both the Curt T-Connector Vehicle Wiring Harness, part # C55532 and the Hopkins Vehicle Wiring Harness, part # HM11142435 will serve the same purpose and install on your 2009 PT Cruiser in the same manner. Over time, we have had more responses from customers that are more favorable toward the Curt # C55532. I have attached links to installation videos for both of these harnesses you can check out.
  view full answer...


• What Is The Difference Between Curt And Draw-Tite Trailer Hitches For 2009 Chrysler PT Cruiser
• You are correct that the instructions for the Curt hitch do require 4 bolts on each side, making that a total of 8 bolts for installation. Both of the hitches have been designed and tested for the weight capacities listed. Curt warranty does require the use of a stabilizing strap like part # 18050. The # C11132 and # 24759 are both Class l hitches with 2,000 lb towing capacity and 200 lb tongue weight capacity. I spoke with my contact at Draw-Tite and they told me the reason for using...
  view full answer...


• Firestone and Air Lift Coil Spring Air Bag Comparison for a 2010 Chrysler Town and Country
• The Air Lift 1000 Air Helper Springs, # AL60814, and the Firestone Coil-Rite Air Helper Springs, # F4169, are very similar systems. The main difference between these two systems is that the Firestone system includes upper supports that are placed between the air bags and the jounce bumper bracket. Both systems will install the same way on your 2010 Chrysler Town and Country with the exception of the upper supports for the Firestone kit. I have attached the installation instructions of...
  view full answer...


• Is the P3 Brake Controller Better than the P2
• The P3 # 90195 is an excellent brake controller. It has an easy to understand diagnostic feature and a lot of different setting options that the P2 doesn't have so I think you will be very happy with it. The P2 and P3 install the exact same way. I have included a link to a video review of the P3 for you.
  view full answer...


• Comparison Between Tekonsha P2 and P3 Brake Controllers
• As far as function goes, the two controllers are actually pretty similar. The primary difference between the two is that the P3 uses what I would call a more user friendly display. Instead of an error code like what's displayed on the P2, the P3 will actually spell out in plain English what the problem is. The P3 also offers 5 preset storable settings that allow you to dial in your preferred settings for up to 5 different trailers. If you'll only be towing one or two trailers, this feature...
  view full answer...


• Is There an etrailer Trailer Hitch Receiver for a 2018 Chrysler Pacifica with Glossy Finish
• Yes, you can get the matte finish with the etrailer Trailer Hitch Receiver part # e98903 or gloss with the Curt Trailer Hitch Receiver part # C13383. They are the exact same hitch aside from finish. There really isn't a benefit for one over the other, it's more or less preference. I find that the matte finish blends in with the underbody paneling better on certain vehicles but it's again mostly preference.
  view full answer...


• Comparison between Curt Hitches for 2017 Chrysler Pacifica
• There are two main differences between the Curt hitch # C13383 and the Curt Hitch # C65CR. First the # C13383 has a visible crosstube and the # C65CR has a hidden crosstube given it a sleeker look. Also, the # C13383 is confirmed to fit both hybrid and non-hybrid models, but the # C65CR will not fit hybrid models of the Pacifica. Both hitches are corrosion resistant powder coated and require no drilling for installation. They also both have 4000 lb towing capacities and 5000 lbs capacities...
  view full answer...


• Is There a Difference Between the Hitch Receivers Offered for the 2007 Chrysler Pacifica 4.0
• The two hitch receivers offered for the 2007 Chrysler Pacifica, Curt # 13529 and Draw-Tite # 75522, are basically identical, have the same towing capacities, and will install in the same way. There really is no way to get around lowering the exhaust and removing your spare tire to ease the installation process so it is highly recommended. Some say that Curt hitches have a better powder coating but for the most part, price is going to be the main difference. Now mattresses on the other...
  view full answer...


• Pressure-Fit Air Lines on Firestone Air Helper Springs, Part # F4169, Used on 2008 Town and Country
• Firestone Coil-Rite Rear Axle Air Helper Springs, part # F4169, do use pressure-fit air hose connections as you noted. I spoke to a technician at Firestone about the concern of the air lines staying place. He confirmed that the fittings used are barbed and that with the moderate maximum pressure of this system, 35 psi, that it is very unlikely for an air hose to come loose from the bag or the inflation fitting. The other part you reviewed, Air Lift AirLift 1000 Air Helper Springs, part...
  view full answer...