Replacement Coupler for Meyer Snow Plow Male Hose and Female Block - 1/4" NPT

Video Transcript for Review of SAM Snow Plow Parts - Snow Plow Replacement Parts - 3371304029C

Today we're going to take a quick look at the replacement coupler with male hose and female block for Meyer's Snowplow.This is going to have a quarter inch NTP opening and it's going to replace that coupler number 1-5-8-4-7-C for your snowplow.And basically we'll have our male end that's going to fit into the female end. It's going to be a little hard without the hoses in place, but basically you'll pull this ring down, and that will allow you to put in the other end. Want to make sure you have it fully retracted there, and then press in fully, it's a little hard to see with my hand in the way there. Then that will hold really securely on our two pieces. To disconnect, you'll pull that ring back and it should spring out of place.So this is going to replace those parts on your snow plow, get you back out on the road, and plowing effectively.As far as our dimensions with this, our female end is overall going to be about 2 3/4" long, and the widest point it's going to be just over 1" in diameter. About an 1 1/8" there.

Our male end is going to be about 3/4" at its widest point, and then it's going to be about 1 3/8" or 1 5/8" there, as far as length, going from that little tip to the end.This product is also made in the U.S.A.And that's going to do it for our quick look a your replacement coupler with male hose and a female block for Myers snow plow.