Custom Underbed Installation Kit for B&W Companion 5th Wheel Trailer Hitches

B and W Fifth Wheel Installation Kit - BWGNRK1007-5W

Install a Companion fifth-wheel hitch in your truck bed with this custom kit. Better than a traditional mounting kit, this setup doubles as a gooseneck hitch when the fifth wheel is removed, and the underbed design allows for full bed access.

Features:

• Lets you install your B&W Companion 5th wheel trailer hitch (BWRVK3500 or BWRVK3400)
• Doubles as heavy-duty Turnoverball gooseneck trailer hitch
  • Includes rails, gooseneck hitch head, safety chain loops, and hitch ball
• Provides complete truck bed access when you're not towing
  • Single hole in center of bed is mounting point for hitch
• Installs easily using existing holes in your vehicle's frame
  • No welding or frame drilling required
  • Truck bed does not have to be removed
  • 4" Diameter hole must be cut into bed
• Powder coated steel is sturdy and corrosion resistant
• Made in the USA
• Limited lifetime warranty

B&W Turnoverball Gooseneck Trailer Hitch

Not only does this kit provide you with a sturdy, custom base for installing your Companion fifth-wheel trailer hitch in the bed of your truck, but it also doubles as one of the most recognizable gooseneck hitches on the market. This fifth wheel installation kit actually is the Turnoverball gooseneck hitch from B&W.

Gooseneck Specs:

• Gross towing weight: 30,000 lbs
• Vertical load limit: 7,500 lbs
• Ball size: 2-5/16"

With the B&W Turnoverball underbed gooseneck trailer hitch you get the best of both worlds. When you go to tow a gooseneck trailer, the Turnoverball creates a sturdy, dependable connection with your trailer. And when you're done towing, you can stow the ball upside down in the hitch to get full bed access and a clean appearance. When you're ready to tow your fifth wheel trailer, just install the Companion in the ball hole in place of the gooseneck ball and lock the post in place using the built-in handle. You can remove the fifth wheel when you're done towing, leaving your truck bed open once again.

Simple, Custom Installation

This kit is custom designed for your vehicle. The mounting brackets bolt to existing holes in your truck's frame. While some modification is required - you will need to cut a 4" diameter hole in your bed for the hitch ball and drill holes for the built-in safety chain loops - there is no need to weld onto or to drill into your frame.

Once you have the brackets and center section installed, set up the operating handle. This handle is designed to be accessed from the rear driver's-side wheel well. On the end of the handle is the heavy-duty steel pin that secures the mounting post of the Companion (or the base of the gooseneck hitch ball).

GNRM1007 B and W Turn Over Ball Under-Bed Rail Kit

GNRC959 B and W Turn Over Ball Center Section

Installation Details 

This Product Fits The Following Vehicles

• 2008 - 2013 GMC Sierra 1500 - 8 Foot Bed
• 2014 - 2018 GMC Sierra 1500 8 Foot Bed
• 2007 - 2007 GMC Sierra New Body 1500 - 8 Foot Bed
• 2008 - 2013 Chevrolet Silverado 1500 - 8 Foot Bed
• 2014 - 2018 Chevrolet Silverado 1500 8 Foot Bed
• 2007 - 2007 Chevrolet Silverado New Body 1500 - 8 Foot Bed