This SAE to alligator clips cable connects your 12V battery to the Goal Zero spade to SAE cable.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi there. I'm Michael with etrailer.com. Today, we're gonna take a quick look at this Goal Zero connector cable. This is going to allow you to connect your SAE fitting with these alligator clamps, so that you can hook up to your battery very easily. Just put these on the positive and negative terminals on your 12 volt battery. And then the SAE connector will connect to your Goal Zero 10 amp or 20 amp solar charge controllers that you can very easily charge up your battery with your solar panel or whatever it is that you're using to charge up that charge controller.
These alligator clamps are gonna be very easy to get connected onto your battery's terminals. Our overall length here, and we're just shy of 24 inches. When I measured it from end to end, it was at 23 1/2 inches. And the red cable here is gonna be a little bit longer than that black cable, so that you can connect very easily there. So, this does feature a 12 gauge wire, so it is gonna do a good job for you allowing that power to flow through to charge up your 12 volt battery.
So, that's gonna complete our look for today. Again, I'm Michael with etrailer.com. Thanks for watching..
Average Customer Rating: 5.0 out of 5 stars (2 Customer Reviews)
This SAE to alligator clips cable connects your 12V battery to the Goal Zero spade to SAE cable.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.