Customers compare STL73RB to these similar products
Products Featured in this Video
Hi, everyone. Aiden here with etrailer.com. Today, we're gonna be taking a look at this LED taillight from Optronics and showing you how to install it. Let's get started. You're gonna get all your normal taillight functions. We've got our running light on right now.… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
There may be a bunch of different reason why your Lippert Level-Up system has suddenly stopped working. The most common reasons are due to a dead battery, extending your jacks too far, or a blown fuse. The first thing you should check for is the easy…
view full answer...For your Karavan trailer I recommend LED tail lights #STL57RB and #STL56RB. They are a little shorter at 6-1/16 inches but they do mount on studs spaced 2 inches apart on center. they are 3-5/8 inches tall and 2-1/4 inches deep overall. I have linked…
view full answer...If the leaf spring stack is currently attached below the axle, which is what it sounds like, then you can use an over/under conversion kit. If the axle is 3 inches in diameter then you can use #K71-385-00. If the axle is 2-3/8 inches in diameter use…
view full answer...Yes, the 20 ft. 4-Way plus Wiring part #A20WB that you referenced will work great with LED trailer lights. There's no reason that it wouldn't work. This is a wishbone wiring kit for the running light circuit which means that the running light…
view full answer...I did some research on your spindles because I was not able to find anything on our site, and it turns out your 1 3/8" spindles are obsolete and replacement parts are no longer available. With that being said, I recommend changing out your…
view full answer...The issue you are having still sounds like there might be a weak or bad ground on the new LED lights. The mix between them and the incandescent assemblies at the rear of the trailer should not be causing this problem so it has to be something…
view full answer...If you wish to attach all of your lights to one dedicated ground wire that will work fine for you. Please be aware that modifying the mount in any manner will void the warranty for the light. The #MCL67AB light is designed to be grounded through the…
view full answer...Your old trailer lights like #MCL67AB are grounded to the trailer via their mounting hardware. Since your new lamps use 2 wires, you'll connect the red wire to the trailer running lamp circuit and install a ring terminal on the end of the black…
view full answer...When a single function light only has 1 wire, like the Thinline LED Trailer Clearance or Side Marker Light #MCL67AB, it means that it grounds through the mounting hardware. If the mounting location doesn't have a clean, bare-metal surface then…
view full answer...The options you have are as follows; lower the tow vehicle, raise the trailer, or tow nose high. The best option would be to lower the truck a few inches so you can tow the trailer level without raising it more. However, this is going to be the most…
view full answer...3500 lb axles have the most common and most consistent spindle sizes. They are typically 1.73 inches at the seal, 1.38 inches at the inner bearing and 1.06 inches at the outer bearing like #TRU24FR. I've attached a video to assist. I've…
view full answer...I was able to pull up some information on the Triton 08478 light that you mentioned and it appears that the LED Trailer Tail Light w/ Flange - Stop, Turn, Tail - Submersible - 6 Diodes - Oval - Red Lens #STL73RB is the same part. I've linked a…
view full answer...