Customers compare E19146 to these similar products
Info for these parts were:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The service plan for the Galeo Pro part #GA94FR is offered in three time frames currently: Monthly/yearly/3-year service available from Galeo at $1.99/$19.99/$49.99.
view full answer...We have the Timbren Axle-Less Trailer Suspension System #A35RD545E you can use to replace your current axle. We do not currently carry a traditional axle that matches your dimensions and one would have to be custom made. This system includes all new…
view full answer...There are 3 different mounting bracket styles depending on how exactly you're wanting to install the Premium Slim LED Strip Light #TN38ZR: - Standard Mount #TN22VR - 45 Degree Mount #TN34ZR - 90 Degree Mount #TN54ZR These different styles will…
view full answer...Instead of securing your marching band equipment from the floor you could secure it from the wall using the Erickson Vertical E-Track #E19146. You can then use the Erickson E-Track Tie-Off w/ D-Ring #E59143 to provide tie-down attachment points or…
view full answer...The height of where you install the E-track will depend greatly on where it will work best for the cargo you plan to tow. Most people put it around half way up or lower. But once again that will just depend on where it will work the best for you. You…
view full answer...The weld bracket on the top of the Ark Drop Down Corner RV Stabilizer Jack Kit #ARK34FR is 4.6063" long and the surface that would make contact is 1.8307" wide. The overall width is 2.8543" on the top. I have attached a dimensional…
view full answer...The correct product to use to support the boards you plan on using to support the bed would be the E-Track Wood Beam Socket #59149. Since you will want to have the 2 by 4s on edge to support the plywood, and the only way the #59149 could be installed…
view full answer...In order to re-seal the panels on your trailer you can use the TremPro 644 Silicone Sealant part #0160297 as an alternative to the Loctite Urethane Sealant part L0150811. The TremPro 644 Silicone Sealant has a similar compound to the Loctite Urethane…
view full answer...The 1" Long Black Torx Wall Liner Screw #WLS100 is the best option for the plywood installation. These screws are fine thread and made for metal studs. They have a tapping edge but often a starter or pilot hole should be drilled. You can then…
view full answer...The width of the Optronics Flexible LED Light Strip #UCL90CB is about 3/8". I have attached a review video where we take this measurement for you to check out. To help remove the 3M adhesive I recommend using some heat like a hair dryer or…
view full answer...Aluminum is a pretty soft metal. Especially as thin as you mentioned. I wouldn't recommend self tappers for the e-track. Instead I would recommend appropriately sized nuts and bolts on either side of the track with larger washers.
view full answer...That is going to come down the thickness/type of metal underneath the 3/4" plywood floor on your trailer. If the metal is the frame or crossmember and is made of steel then the Snap-Loc E-Track Self-Drilling Metal Screws - Qty 20 #SL99FR would…
view full answer...