Timbren Trailer Suspension - Leaf Spring Suspension - TTRA1032 Review Video

Hey Beatrice, To find the right fit for your trailer's suspension you'll need to take a quick measurement of your current shackle straps. You'll need to measure from the center of one bolt hole to the center of the other bolt hole. The…

There unfortunately isn't a guide to tell us the equalizer, shackle straps, and leaf spring sizing for your 2016 Grand Design Reflection 313RLTS so you'll need to a bit a of measuring to determine the best replacements. Before measuring…

The brackets on the SumoSprings Trailer Helper Springs #SS26MV are 1-1/2" wide so they will fit evenly across the humps on your spring pads. I do not recommend cutting down the spring and you will be able to use these even with only having…

I'd be happy to help, but you're going to need to measure the current equalizers on your 2021 Keystone Hideout 29DFSWE to confirm that the MORryde #MR87ZR are going to fit. The #MR87ZR measure 6-1/2" center to center of the horizontal…

What you are experiencing is common on tandem axle trailers when little or no weight is on them. The weight compresses the suspension and would not allow this to happen, or at least not as easily. If you were to use the E-Z Flex Equalizers…

The shackle strap length is measured from the center of one bolt hole to the center of the other. The Dexter Heavy Duty Suspension Upgrade Kit for Single Axle Trailers - Double Eye Springs #K71-358-00 uses 3-1/8" long shackles which are found on…

If the equalizer dimensions are pretty close to the dimensions of the E-Z Flex Equalizers #K71-655-00 that you referenced and less than 8,000 lbs axle capacity then the equalizer will fit and work well. It would be a direct replacement.

Yes, the Roadmaster Comfort Ride Add-On Kit #RM-2450-50 can be installed on trailers like yours that have the leaf springs mounted above the axles. I have actually attached an image from the complete installation manual that shows this orientation.…

Since the eye-to-eye measurement of your current equalizer is 7-3/4" just like the E-Z Flex #K71-655-00, and the height difference is only 1/4" you can use this kit. The 35" spacing is the standard spacing that Dexter Axle usually has…

Yes, the MORryde Suspension Upgrade Kit #MR46ZR that you referenced is correct replacement wet bolt, bushing, and shackle kit for the CRE3000 kit that you have.

If you are getting inside tire wear on the rear axle of your fifth wheel that would indicate that your trailer is sitting a little nose high and putting additional stress on the rear axle. If you look at your trailer when it's connected to your…

You will measure the MORryde Suspension Upgrade Kit for Tandem Axle Trailers #MR76ZR from the center of each hole on the shackle strap.