Troubleshooting Ultra-Fab Electric Jack Has no Power When Lifting Trailer
Question:
Hello, I am having a problem with my trailer jack, Ultra-Fab Products Camper Jacks - UF38. It will lower fine, but it has no power when lifting. It has worked fine for years so I am not sure what is happening. Thanks,
asked by: Peter
Expert Reply:
It sounds like you're saying it is hooked up to power but it doesn't have the ability to raise the trailer. This could be the batteries or a problem with the wiring. It is probably getting power, it just may not be enough to lift the trailer. I would start by checking the wire running to the jack using a circuit tester like # PTW2993. You could also double check the trailer batteries.
If you find it has 12V power and still isn't working it may be that the motor is giving out. It would still be able to lower the trailer since it is has the weight and gravity to help but just can't put out the required power to lift it. It could also be a different internal issue, it is hard to say. Since you said it has worked fine for years it is unlikely it is under warranty unless you have the # UF38-944040 with a 10 year warranty. The best option would be to replace it.
Products Referenced in This Question
Product Page this Question was Asked From
Phoenix Electric Trailer Jack - A-Frame - 22-1/2" Lift - 4,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- With Round Foot
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: progressive dynamics
- Shop: Phoenix Electric Trailer Jack - A-Frame - 22-1/2" Lift - 4,000 lbs
- Shop: Progressive Dynamics 1800 Watt Inverter w/ Transfer Switch
- Shop: Progressive Dynamics Lithium 60A 4500 Series Inteli-Power Converter Section
- Shop: Electric Trailer Jack - Drop Leg - A-Frame - 22-1/2" Lift - 3,500 lbs
- Shop: Ultra-Fab Electric A-Frame Jack w/ 2-1/4" Tubing - Drop Leg - 22-1/2" Lift - 4,000 lbs
- Shop: Ultra-Fab Electric A-Frame Jack w/ 2-1/4" Tubing - Drop Leg - 23-1/2" Lift - 3,500 lbs
- Shop: Ultra-Fab Electric A-Frame Jack w/ 7-Way Plug - 18" Lift - 3,500 lbs
- Video: Ultra-Fab Electric A-Frame Jack Installation
- Video: Review of Progressive Dynamics RV Inverters - 1,800 Watt Pure Sine Wave Inverter - PD44FR
- Q&A: Troubleshooting A Non-Working Ultra-Fab Phoenix Electric Trailer Jack
- Q&A: Options if an Ultra-Fab Phoenix Electric Trailer Jack Has a Bad Circuit Board
- Q&A: Why Does My Electric Trailer Jack Beep when the Trailer is Not Hooked Up
- Q&A: Troubleshooting Ultra-Fab Phoenix Electric Tongue Jack That Won't Extend or Retract
- Q&A: Troubleshooting Phoenix Electric Trailer Jack for Beeping
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Video: Progressive Dynamics Pure Sine Wave Inverter Install - 2007 Four Winds Dutchmen Motorhome
- Search Results: trailer jack
- Q&A: Troubleshooting Ultra-Fab Electric Jack Has no Power When Lifting Trailer
- Search Results: electric jack
- Video: Review of Progressive Dynamics RV Inverters - 2,000 Watt Pure Sine Wave Inverter - PD64FR
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Q&A: Is The Progressive Dynamics Pure Sine Wave Inverter # PD44FR Compatible With Lithium Batteries
- Search Results: 60692
- Shop: Brake Controller
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Video: Phoenix Electric A-Frame Trailer Jack Review
- Article: Stability Control for Heavy Duty Vehicles
Peter
4/17/2024
Can you tell me if the brushes can be replaced in this jack and what the process is? Thanks,