Tow Mirror Recommendation for 2023 Toyota Highlander

Question

Question:

Will this towing mirror work on my 2023 Toyota Highlander?

asked by: Ed D

0

Expert Reply:

For your 2023 Toyota Highlander you would need to go with a universal style of tow mirror like the K-Source part # KS3990 which we have test fit on similar Highlanders and found the fit and worked great (see install video link). There are no custom fit tow mirrors made for your vehicle.

expert reply by: Jameson C

0

Answer 1

I feel the CIPA Universal Towing Mirrors #7070-2 are the best option for your 2023 Toyota Highlander since there are no custom fit mirror options. These mirrors have a simple strap system which is less likely to fail compared to other complicated…

view full answer...

Answer 2

I attached a picture that has a diagram of where all of the wires of the 4 way to 7-way adapter part #30717 run when installing it. Basically the blue wire goes to the brake output circuit of the controller, the black to the positive post of your…

view full answer...

Answer 3

The Curt Echo Mobile wireless brake controller part #C51180 is a great option that does minimize wiring to install and does still allow the trailer battery to charge via the 12 volt accessory circuit of the 7-way. Since you have an active 4-way…

view full answer...

Answer 4

The Curt #C51180 will work just fine with a vehicle that is equipped with an OEM or aftermarket brake controller. The Echo will not receive any output from the existing controller, as the Echo doesn't have a pin to receive any output from the…

view full answer...

Answer 5

The first thing you will need to do to get a 7-way and brake controller installed on your 2022 Toyota Highlander is to get a 4-way connector. The T-One Vehicle Wiring Harness with 4-Pole Flat #TK99FR will be plug directly into existing wiring located…

view full answer...

Answer 6

The Tekonsha Prodigy RF Wireless Trailer Brake Controller part #90250 must be mounted with 5 degrees of level on a horizontal plane lined up with towards the tow vehicle for the internal sensor to work properly. The sensor will not function if the…

view full answer...

Answer 7

The two systems you mentioned are basically the two best systems available for weight distribution. Either one will work great for you as long as it is properly rated for your setup and is properly installed/set up. Personally I like the Reese Strait…

view full answer...

Answer 8

If you are just looking to tow a trailer with lights and without brakes, I recommend the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part #C56349. This will give you a 4-Pole flat on the back of the Tacoma to tow a…

view full answer...

Answer 9

Since your tongue weight is right at 350 lbs I would recommend going with the Reese SC Weight Distribution Hitch part #RP66540 which would be an excellent choice. This system uses trunnion bars which will give you better ground clearance when…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...