Hydraulic Brake Kit Parts to Fit 3,500 lb Trailer Axle

Question

Question:

Hello, I am interested in a brake kit for a boat trailer: T43397007K brake cylinder, AKHD-545-35-K hub brake drum x 2 pieces, AKUBRK-35-D hydraulic brake kit and T1087400 hydraulic hoses, please check if this kit will fit.

asked by: Hydraulic B

0

Expert Reply:

The parts that you mentioned will work together:

Titan Zinc-Plated Brake Actuator - # T43397007K
Hydraulic Trailer Brake Kit - # AKUBRK-35-D
Trailer Hub and Drum Assembly - # AKHD-545-35-K
Titan Hydraulic Brake Lines with Fittings # T0776500

If you have torsion axles then the brake line kit will work great, otherwise I recommend going with a brake line kit like part # 18SI-BLKIT or # HS496-252 which are designed for standard trailer axles.

expert reply by: Jon G

0

Answer 1

The replacement orifice connector for that Titan model 20 master cylinder is part #T1209800.

view full answer...

Answer 2

Yes, the Replacement Solenoid Adapter Fitting for Titan Model 10 Brake Actuators, part #T4750200, is for pre-2000 Titan Model 10 brakes. If you have a newer Titan Model 10 brake, you will use the Orifice Connector for Titan Actuators Item #T1209800.…

view full answer...

Answer 3

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 4

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 5

I spoke to Dexter and they said there is a bit of a process for installing the spindle nut properly. 1. You will need to thread on the inner nut, rotate the hub, then tighten the nut to 100 foot pounds. 2. Loosen the nut to remove the torque, making…

view full answer...

Answer 6

Mounting hardware does not come with the replacement gear box part #RVLG-RDBOX.

view full answer...

Answer 7

Good question, and there is just one difference between the Dexter disc brake actuators you asked about, which is the overall length: - 17-1/2" Overall length: Dexter DX7.5L A-60 Brake Actuator #DX63FR - 19" Overall length: Dexter DX7.5L…

view full answer...

Answer 8

When our installers replace a trailer hub, there isn't a set torque spec used when tightening the spindle nut. The hub is placed on the spindle, making sure the inner and outer bearings are correctly seated. The spindle nut is then run down until…

view full answer...

Answer 9

I recommend replacing your current surge brake coupler using either using the Demco Hydraulic Brake Actuator for Disc #DM8104311 or Drum #DM8102511 brakes. I prefer these couplers as they have a Zinc finish which best resists corrosion.

view full answer...

Hydraulic Brake Kit Parts to Fit 3,500 lb Trailer Axle

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching