Adjustable RV Hitch 500 lb. Tongue Weight

Question

Question:

I have a 2021 Keystone Outback at. The frame is 72inch wide. It appears though you have one hitch that will go that wide, but it has a tongue weight of 350 lbs. I intend to put a generator on a platform on the hitch and really need the 500 lb tongue weight, but it only goes to 66. Any recommendations?

asked by: Bill B

0

Expert Reply:

The Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide, # 13703. Is our only option for that width, rated at max TW of 350 lb. Anything for that span exceeding 350 lb. will probably need to be custom fabricated.

expert reply by: Michael R

0

Answer 1

I believe I have a better solution, the Curt Hitch part #C13701 has a 500 lb capacity that will fit trailers that have frame members that are between 18 and 51 inches apart. Whether or not you could replace your current bumper with one rated for 500…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 6

We highly recommend against double towing and many states either don't allow double (some states call it triple) towing or have numerous restrictions. Some states limit the total length of all 3 units, some only allow certain types of trailers…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

The puck feet on the Gen-Y Hitch Gooseneck Trailer Hitch for Dodge Ram OEM Puck Systems #GY83XR is just to help stabilize the ball mount and does not lock into place in the puck. The locking mechanism on top will lock the shank into the gooseneck…

view full answer...

Answer 9

I went out to the warehouse and measured Curt trailer hitch #C13704 for you. The distance from the top of the mounting flanges to the top of the cross tube is 2 inches. I have included some pictures with additional measurements for you.

view full answer...

Answer 10

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 11

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue with them is comfortability when you…

view full answer...

Answer 12

To replace the motor on the LCI Pump 650057 we have the Replacement Motor #LC167576.

view full answer...

Adjustable RV Hitch 500 lb. Tongue Weight

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching