RV Pull Out Step Solution for Hay Wagon with 33 inch Floor Height

Question

Question:

Im look for a set of steps for my Hay wagon. Im custom make the back in to use folding trailer steps. The Trailer floor height is 33 inches. How do I know what i need?

asked by: Jason J

0

Expert Reply:

For a 33 inch floor height I'd recommend a 4-step pull out step setup like the Flexco Manual Pull-Out Steps for RVs # SMFP-4400 over a 3 step as you'll want that extra step based on the height you have.

To help attach the steps to your RV a set of outriggers # LC301704 would be your best option. These will easily attach to your trailer frame and give a set of brackets for the steps to secure to.

expert reply by: Jameson C

0

Answer 1

RV makers typically do not maintain detailed specs on items like the step assemblies they install in production of their trailers like your 2017 Keystone Premier 26RB bumper-pull. Based on my research your OEM step unit was a 3-step manual type. The…

view full answer...

Answer 2

The closest RV step we offer to 27 inches in width is the Flexco triple step #SMFP-3200L that measures 27-1/8 inches in total width. You might need the outriggers part #LC301704 to move the brackets out to install the steps if yours is 27 inches…

view full answer...

Answer 3

Really you're going to need to measure the distance where the leveling system is going to be installed. If that distance is more than 20', then you're going to want the 6 point Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling…

view full answer...

Answer 4

I spoke with the manufacturer to ensure the measurements were correct and found that the chart on the page for #LC432690 is incorrect. It does require 27-1/2" of space for the mounting brackets. Both the #LC432690 and #LC432696 will be too big…

view full answer...

Answer 5

Kenny, those bolts for the B&W Companion 5th Wheel Trailer Hitch #BWRVK3500-5W should be torqued to 40 ft. lbs. Also, the pivot arms would need to be torqued to 80 ft. lbs, the draw down bolt should be tighten to 60 ft.lbs and the arms should be…

view full answer...

Answer 6

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Answer 7

Though safety chains to do not come with a Reese Goose Box 5th-Wheel-to-Gooseneck Air Ride Coupler Adapter such as RP94623 they are available by using the Tow Ready Safety Chain Kit #49150. If you look at the accompanying photo you can see exactly…

view full answer...

RV Pull Out Step Solution for Hay Wagon with 33 inch Floor Height

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching