Depth of the Epicord Battery Disconnect Switch with Key # 277-000096 From the Plate to the Key

Question

Question:

How far in depth is the key and black plug stick out from the white plate

asked by: Mike

0

Expert Reply:

I went out to the warehouse and found that from the white plate to the furthest point on the key measures 2-5/8" for the Epicord Battery Disconnect Switch with Key # 277-000096. I have attached a picture for a visual.

expert reply by: Jon G

0

click to enlarge

Answer 1

The only time the key of the Epicord Battery Disconnect Switch with Key #277-000096 can be removed is when the key is in the off position. The key has to be installed for it to be in "ON". And by "ON" that refers…

view full answer...

Answer 2

Your leveling system is not supposed to lift the wheels off the ground; this could exceed the capacity of your leveling system and cause damage and I do not recommend doing so. If you can make any adjustments to the legs then you will want to go…

view full answer...

Answer 3

For your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote #LC358590, the correct replacement rear foot pad is the Replacement Rear Foot Pad for Lippert Components Ground Control 3.0 #LC377962.

view full answer...

Answer 4

If you get the Out of Stroke error message on the Lippert Ground Control system, such as #LC358590, then that indicates that the jack has extended as far as it will go and cannot go any further. To clear the error you can extend all of the jacks in…

view full answer...

Answer 5

Yes, the Epicord Battery Disconnect #277-000096 would be a great switch choice for you to install on the horse trailer to ensure that all the power is on and off to your accessories with one switch to the deep cell battery. I have linked it to this…

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 8

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 9

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 10

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 11

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 12

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Depth of the Epicord Battery Disconnect Switch with Key # 277-000096 From the Plate to the Key

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching