How Tight to Get Latch of Multi Fit Ball Coupler on Hitch Ball
Question:
How much do you tighten the adjuster knob once the ball is inside?
asked by: Gustavo
0
Expert Reply:
The tightness needed for latching the Titan Zinc-Plated Brake Actuator # T43397007K to a ball successfully is "hand tight" which means you'd get it snug by hand which means the latch will be tight enough to secure to the ball but not so tight that movement is restricted.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Zinc-Plated Brake Actuator - Drum - Multi-Fit Ball - Bolt On - 7,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Straight Tongue Coupler
- Bolt-On
- 7000 lbs GTW
- 1-7/8 Inch Ball Coupler
- 2 Inch Ball Coupler
- Drum Brakes
- No Lockout
- Dexter
more information >
Continue Researching
- Q&A: Replacement Drum Brake Actuator for a 1995 4 Winns Model 3916 Trailer
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement for Atwood Surge Brake Actuator 82541
- Q&A: Surge Brake Actuator Recommendation to Replace Fulton A60 on Trailer
- Q&A: Best Replacement for Atwood 82543 Brake Actuator
- Q&A: Can the Replacement Atwood Master Cylinder 85736 Still Be Obtained
- Q&A: How to Keep LED Turn Signal Lights on Toolbox From Flashing with Brake Pedal Pressed
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)