Roof Vent Recommendation for 1961 Little Gem Trailer

Question

Question:

Im looking for a vent/skylight for a 1961 Little Gem. The opening inside is 13 3/4 square. Is the product measured from the size of the opening? If so, is a custom fit available? Thank you.

asked by: Leslie

0

Expert Reply:

The Ventline Roof Vent # V2092SP-28 is the standard size that requires a rough cut opening on the roof of your trailer of 14-1/4 inch by 14-1/4 inch.

If you have a 13-3/4 inch square opening you'd need to open yours up a bit to get this to fit.

expert reply by: Jameson C

0

Answer 1

All of our standard roof vents, such as the Ventline Ventadome #V2092SP-28, are designed to install into a 14" x 14" or 14-1/4" x 14-1/4" rough opening. This is the standard vent size for trailers and RVs so…

view full answer...

Answer 2

We do have many types of RV vent items you can see on the linked page including manual and fan-powered models, however, none measures 10 x 10. The vast majority of RV roof vents in use are 14 x 14-inches, like #V2092SP-28, and fit into roof…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 4

You can use a 7-Way and 4-Way connector at the same time just as long as you are not overloading the light circuits. If your camper has a lot of outside lights like running lights, and brake/stop/turn lights then the lights that perform the same…

view full answer...

Answer 5

The Reese Titan Extension/Reducer you referenced, part #RP45292 would work great with the 2-1/2 inch Class V hitch on your Ram. As you mentioned, the extension has a 8K capacity when cut down to the 24 inch length, that will provide a 2 inch receiver…

view full answer...

Answer 6

The closest modern tire size to a 7.00-15 tire is a 225-75-15 like the #AM10256 tire you mentioned. Typically, a 225/75-15 tire will measure about 8-3/4 to 9 inches wide by around 28-1/2 inches in diameter. We offer the same size in a Load Range E as…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

The Demco Hijacker Autoslide 21K #DM8550038 weighs approximately 305-lbs. The head of this hitch weighs around 70-lbs and can be removed to help make moving and installing this 5th wheel hitch a little bit easier.

view full answer...

Answer 9

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 10

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 11

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 12

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Roof Vent Recommendation for 1961 Little Gem Trailer

Product Page this Question was Asked From

Continue Researching