Thule ProBar Crossbars Review Video

The minimum crossbar spread for the Thule Hullavator Pro Kayak Carrier and Lift Assist with Tie-Downs #TH898 is 24" - meaning from one point on the front crossbar to the same point on the crossbar has to measure at least 24" for the…

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

To mount the Go Power solar panel like #34282182 to the Rhino-Rack crossbars you would need to adjust the crossbars to the correct width for your panel. Then you can use the Truck Rack T-Slot Fit Kit for Malone Kayak Carriers #MPG8287 or Crossbar…

The Thule Hullavator part #TH898 cannot be used on factory bars because it requires a bar that sticks out past the feet of the rack by 4 to 8 inches and factory racks have their bars flush with the feet of the rack. Also not all factory racks would…

The nc code on the Tekonsha Prodigy brake controller indicates that no trailer is connected. When you step on the brake pedal though it should still say that the trailer is not connected. It is possible that there is a short being caused by a dirty…

I could not find purchase history for a brake controller based on your email address but I do note that you referenced a question regarding the Curt Tri-Flex #C24VV. With this brake controller the code RC indicates that the unit needs to be…

We do have what you need, but the Replacement Rubber Strip for Thule Aero Load Bars #TH853354407 is not the correct part for the ProBars. I contacted the manufacturer regarding the correct replacement rubber strip for your Thule ProBar Evo's and…

For a square crossbar set the longest we have is the 60" Thule SquareBar Evo #TH712500. The longest crossbar available is the 80" Yakima CoreBar Crossbar #8880656 which comes as a single crossbar, but we also have the 79" Thule ProBar…

The width of the C channel that connects the 54 inch Rhino-Rack Vortex Crossbar to the foot is 1 inch and the width of the opening is 1/2 inch. The depth of the channel is 5/8 inch.

The channel on the Rhino Rack Roof Track, part #RRRTV148 is 0.86 inches (a little less than 7/8 inches) by 0.19 inches (a little less than 3/16ths inch). I've included a diagram showing these dimensions. The upper channel is about 5/8 inches…

Here are the 2 different mounting options for installing the Batwing and Foxwing Awning Relocation Kit #RR31102. You can change the orientation of the brackets so that the awning will either hang higher or lower depending on your application.

The tracks of the Rhino Rack Roof Rack System part #Y02-500B are 1-1/2 inches wide by 1/2 inches tall. The length of the tracks is 63 inches. The feet height for this is 3 inches which is the distance from the top of the tracks to the bottom of the…