Malone SeaWing Kayak Carrier Stinger Load Assist Review Video

I'll start off by saying that the only trailer with a folding tongue is the Yakima EasyRider Double Decker Trailer - 14-1/2' Long - 78" HD Crossbars - 500 lbs #Y08129, which is 14 feet long and has a capacity of 500-lbs. The issue you…

I do have an option for you but the Roadmaster Direct-Connect Base Plate Kit part #RM-521448-5 is designed to be used with the factory front bumper on a 2018 Jeep JK Wrangler only. Unfortunately, Roadmaster does not test this base plate kit with…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

We offer two Blue Ox base plate kits for your 2009 Wrangler Unlimited. Part #BX1126 is designed for Jeeps that have a standard factory bumper with no winches or guards attached. Part #BX1134 is designed to fit Jeeps that have the Arby Stubby Bar. I…

Round bars can be pretty frustrating to deal with for this reason. Unless the carrier is loaded the Malone MegaWing Fishing Kayak Carrier with Tie-Downs #MPG207 on round bars is going to be able to tilt forward and backwards. This means that when the…

I do have an option for you but it is very unlikely that you would be able to use two of the Malone SeaWing Kayak Carriers part #MPG107MD side by side on the roof of your 2016 Ford Escape. Instead, I recommend using an upright carrier like the Malone…

I cannot say without a doubt that your roof rack could not be damaged by attaching a winch to it to pull the boat. It also may void any warranties that may be on the rack itself or vehicle since it is not designed for that use. However, most of the…

You will need the Threaded Anti-Rattle Hitch Pin Lock #e99047 for the Flint Hill Goods 60" x 22" Cargo Carrier #FHG49ZR

I contacted Malone to see if the MegaWing Fishing Kayak Carrier, part #MPG207, is compatible with the Stinger Load Assist for the SeaWing Carrier, part #MPG350. Unfortunately, they are not compatible. My contact said they have had a few people ask…

If the bolt holes on your torsion axles side mounted brackets are 8" apart on center then you are going to want to use the Torflex Lift Kit part #K71-707-01 for single axle trailers or part #K71-707-02 for tandem axle trailers. As long as you do…

For your 3,500 lb Dexter Torsion axles, you will want to use the Torflex Lift Kit - Tandem Axle - 2-5/8" Lift #K71-707-02. This will provide an additional 2-5/8" clearance. The distance between the mounting bolts is 8 inches center on…

I can absolutely confirm the correct lift kit for your trailer. Based on your photos, you do in fact have a #10 Torflex axle, and they are compatible with the lift kits because you do not have 3" high-profile brackets (which just means the…