Trailer Wiring Harness Installation - 2011 Subaru Outback Wagon C56040 Video

I took a look at the online owner's manual for your 2012 Subaru Outback and found that as long as you have the 3.6L engine, the vehicle is capable of towing a 3,000 pound trailer if it is equipped with brakes. For a trailer without brakes, the…

You are safe to tow up to the full rated capacity of your 2010 Subaru Outback 2.5L. The online owners manual states a maximum loaded trailer weight of 2,700 lbs with a maximum tongue weight of 200 lbs. The manual states this is 8% of the maximum…

The Draw-Tite Max-Frame Trailer hitch part #76227 requires removing the foam bumper support temporarily for installation. The video does show the installer cutting the plastic fascia and then replacing the foam bumper support that comes with the…

For your 2011 Subaru Forester, I recommend the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #118467 over the Curt #C56040. They are very similar units that plug into the cargo area of your vehicle, but we have had less issues with…

The Thule HideAway Awning part #TH490011 offers direct mount installation. Therefore, you'd need to attach the brackets directly to the wall of the trailer. If you have existing brackets, these would need to be removed. I have attached for you…

Yes, the Curt wiring harness part #C56040 that you referenced will work for trailer wiring on your 2012 Subaru Outback as long as it is not a Sport model. I attached an install video for you to check out as well.

You'll want to ensure your current factory hitch can be removed (it should be bolted on and not welded), and if so, there is a trailer hitch receiver with a concealed crosstube that does fit your 2010 Subaru Outback, which is from Curt. Since you…

Per the instructions which are linked for your convenience, the bolts for the Draw-Tite Max-Frame Trailer Hitch Receiver #75876 should be torqued down to 50 lb.-ft. This trailer hitch is a confirmed fit for your 2018 Subaru Forester and I have…

The Draw-Tite Hitch Receiver part #76227 on the 2019 Subaru Outback Wagon requires 4 inch by 4-1/2 inch square cut out on the bottom/center of the fascia. To find the center of the fascia measure 2 inches (toward the driver side of the fascia) from…

My recommendation is for the Draw-Tite Max-Frame Trailer Hitch Receiver #76227. This style hitch will work well for your 2011 Subaru Outback Wagon. I prefer it over the Curt #C13410 as it has the gussets in between the receiver and cross tube that…