Trailer Hitch Installation - 2006 Infiniti FX35 - Curt Video

Functionally speaking, there isn't a huge difference. The Curt #C56382 has a slightly lower capacity at 3 amps for circuit for stop/turn signals and 6 amps for taillights. The Tekonsha #118781 has a capacity of 5 amps per stop/turn circuit and…

The Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #13558 is a confirmed fit for your 2006 Infinity FX35 and does come with all the mounting hardware needed. I've attached the installation details to help. You will only need to…

The maximum amp rating for the T-One Wiring Harness are as follows: Maximum stop/turn light: 1 per side (2.1 amps), Max. tail lights: (4.2 amps). This rating is even with the hot lead pulling power directly from the battery. For your application, you…

I spoke with my contact at Tow Ready about converter #118158. He said that at most the converter is rated for 2.1 amps per side for brake and turn signals so it would not work for you. I recommend going with a kit that bypasses the vehicle wiring…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…