SumoSprings Maxim Rear Helper Springs Installation - 2008 Ford F-53 Video

Yes, since the Super Steer SS400 Trac Bar attaches to the RV frame slightly behind the rear axle center you would be able to also install the Timbren kit part #TFRF53A.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The front set of SumoSprings you'd want for your 2017 Jayco 31UL Precept is the part #SSF-170-40-2 and then for the rear you'd need to go with a Timbren part #TFRF53A or the SumoSprings #SSR-187-54-1.

Yes, the front #TFFF53B Timbren suspension enhancement are similar to the front #SSF-170-40-2 SumoSprings for your 2018 Thor ACE 30.2 Motorhome. Timbren is a little more well-known but we have received feedback from our customers that the SumoSprings…

Believe me when I tell you, of all the questions we get, this is definitely NOT a stupid one, and to answer your question, both the Timbren Rear Suspension Enhancement System #TFRF53A and Timbren Front Suspension Enhancement System #TFFF53B will fit…

The biggest difference between the two for your 2019 Thor ACE 30.2 motorhome, and the reason why I highly recommend the SumoSprings over the Timbren, is what each product is constructed from. The Timbrens are made from a strong, rigid rubber while…

The Timbren #TFRF53A and SumoSprings #SSR-187-40-1 are very similar, which often makes it difficult to decide which is best. Both work independently to help compensate for off-center loads and reduce body roll when swerving and turning corners. They…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…