Roadmaster StowMaster Tow Bar Installation - 2018 Jeep JK Wrangler Video

The RoadMaster 4-Wire Connector #RM-910030-1 has a 1-3/4" center to center spacing for the mounting holes and would require a at minimum a 7/8" wide hole to fit the body of the connector through.

I have a solution for you. However, we do not have an adapter to fit your 4-pin round connector on your trailer. Because of the rarity a 4-way round connector, I recommend either cutting off the 4-way round and attaching a 4-way flat, or splicing a…

I can offer you a solution, though a 7-round to 4-round adapter is not available. What you will need to do is create your own by wiring a 7-round trailer end connector, #PK11700, and 4-round vehicle end connector, #RM-910030-1. I recommend going with…

If you have a 4-way flat connection on you RV and a 4-way round connection on your flat towed vehicle, then I recommend using a the Custer Trailer Connection Adapter, #ADP001. This adapter used with a wiring harness like #18045 will allow you to…

Yes, the 4-way round to flat adapter part #ADP001 that you referenced will work with the RoadMaster 4-Wire Connector #RM-910030-1. It will plug right in and give you a 4-way flat to use.

Sounds like your tow bar may not be sitting perfectly level. If I had to guess it sounds like the tow bar is angled forward and that is causing the wheels to get stuck turned to one side. I attached a help article on how to pick out the correct high…

The Roadmaster Crossbar-Style Base Plate Kit #RM-521453-4 we will only have as an entire kit. The individual mounts are not available with the arms.

Yes, I did some checking and your 2011 Ford Ranger with a manual transmission can be flat towed as-is. You'll need to check the owners manual though for the correct procedures on this. You should be able to just put it in neutral though. For a…

The first thing you will want to do is consult the owners manual for your 2001 Jeep Cherokee to make sure that it can be flat towed and if there are any special requirements or procedure. To flat tow a vehicle there are 5 items you will need: base…

The etrailer base plate kit part #e98948 is a confirmed fit for your 2020 Jeep Wrangler and works directly with the Blue Ox tow bar part #BX4330 and would be a great setup. For lighting you can use the diode kit, #RM-15267, and not have to worry…

The distance between those mounting points for the Roadmaster StowMaster Tow Bar #RM-501 are 28-1/2" on center. I confirmed this with my contact at Roadmaster.

The Roadmaster StowMaster Tow Bar - Car Mount - 2" Ball - 6,000 lbs #RM-501 weighs 57 lbs. That is including the hardware and plates that connect to your base plates, so it will be closer to 50 lbs when you disconnect it.