Demco 4-Diode Universal Towed Vehicle Wiring Kit Installation - 2022 Ford Escape Video

The best charge line kit for flat towing your vehicle is the Roadmaster Battery Charge Line Kit #RM-156-25. I have a hard time not recommending all things Roadmaster when it comes to the wiring for a flat tow system because of how much research…

If your trailer has separate turn signals from the brake lights and you want them to remain that way, you will need to use a special converter. On the trailer side, behind the 7-Way, you will attach the Vehicle to Vehicle Taillight Converter,…

In order to use an NSA Ready Brute Tow Bar with a Roadmaster Direct-Connect Base Plate Kit, you need the Roadmaster Clevis Connectors part 857768004296 which have 3/4" pins. I have attached a list of other parts you will need below as well for a…

I have a copy of the 2013 Honda Fit Owners Manual that I found online, and it states that both manual and automatic transmission equipped Fit models can indeed be towed behind a motorhome IF the specific procedures shown are followed. You can find…

While we haven't had the opportunity to install the Demco Classic Base Plate Kit part #DM9518285 I have included a video on a very similar base plate that we did install recently on a 2013 Ford Fiesta. It will have most of the more involved…

The tabs for the Demco Classic Base Plate Kit #DM9517023 that fits your 1996 Geo Tracker have a 3/4" gap, they measure 3/8" thick, and there is a 1/2" hole for the pin that secures the tow bar to the base plate kit. I've attached a…

The Tracker tow bar #RM-020 has the capacity to tow the 2008 Mazda 3 behind your RV but Roadmaster does not offer base plates for the 2008 Mazda 3. You will need base plates so the tow bar has something to attach to. The only base plates for the…

The correct way to wire up the breaker that comes with the Roadmaster charge line kit part #RM-156-25 is to have the copper post ran to the positive post of the battery that is charging the other vehicle and the silver side to the battery that is…

Vehicles with separate taillights can be wired for flat towing like a combined vehicle with a diode kit like the #RM-15267 and the brake lights will flash like turn indicators when blinkers are on and the brake signal will not override it. This is…

The Rear View Safety Color Monitor #RVS-6139Q will be able to support up to 4 cameras including the Rear View Safety Forward Facing Camera #RVS-776-FF-5P you mention, and comes with a mounting plate. To wire the monitor and the cameras, use the…

The Entegra Coach Vision is built on a Ford F-53 Chassis which means there should be a pre-wired brake controller port under the dash. The exact location of this port can vary but most likely it will be on the left side of the steering column support…

While it is possible to cut the 4-pole connector off of the Hopkins Custom Tail Light Wiring Kit for Towed Vehicles #HM56302 and wire it into a 6-pole socket, you would be doing yourself an IMMENSE disservice using any kind of plug-in tow bar wiring…