B and W Gooseneck Trailer Hitch Installation - 2012 Chevrolet Silverado Video

I spoke with my contact at B&W regarding the Turnoverball Underbed Gooseneck Hitch #BWGNRK1067 for your 2007 Chevy Silverado. He said that a driveway DIYer like yourself can expect an installation time of about 2-3 hours. All of the needed…

I spoke to my contact at B and W and he said that when their hitch balls get frozen up in the hitches like the part #BWGNRK1313 the best solution is to let it soak for along time with penetrating oil like WD40 or PB blaster. He said the more…

A goose neck hitch ball, or the center of a 5th wheel hitch head for that matter, will be located either right over the rear axle or an inch or so forward of it. You do not want a goose neck hitch ball to be located behind the rear axle since this…

I looked at the owner's manual for your 2014 Chevrolet Silverado 1500, and for the 4WD Crew Cab, Standard Box with a 5.3L Engine and a 3.42 axle ratio, the maximum trailer weight for the vehicle to tow is 9,500 pounds. The GCWR (Gross…

Like you said, many factory integrated brake controllers will not work well with electric over hydraulic trailer braking systems. Some of the newer versions of these controllers now have an electric over hydraulic mode. Check to see if any of your…

The Patriot Slider part #BWRVK3270 might be a bit more noisy than the Companion slider part #BWRVK3400 due to the increased number of mounting points, 4 at the corners vs. 1 in the center. Probably not that noticeable and certainly not something…

I might have an option for you but we don't offer just the mounting hardware alone for the B&W Turnoverball Underbed Gooseneck Trailer Hitch part #BWGNRK1012 which fits a 2015 Chevy Silverado 2500. The only advice I have for you to…

Between the Curt #C60692 and B&W #BWGNXA2061 that will fit your 2022 GMC Sierra 3500 with the factory pucks/prep package, I do prefer the B&W. Though both the Curt and B&W are rated up to 30,000 pounds and will fit your truck…

I sent your message and pictures to the owner of the GCH who makes the camera kit part #3460009 and he confirmed that you are correct. He stated that no fuse is needed for the camera. Both red wires are to be connected to a keyed accessory circuit…

The factory trailer brake controllers are not good options for trailers with electric over hydraulic brakes. There are adapters that you can use to be made compatible, the HydraStar Electric Over Hydraulic Actuator Adapter Module part #HBA-CAM but…

Other than there being an issue with the controller itself, you may want to check the towing fuses to male sure they are all still good. I included a picture of the fuse box under your hood and the fuses you will need to make sure are good, but it is…