Stromberg Carlson RV and Camper Hitch - Bumper Mount - BA-100 Review Video

The 2 inch RV Bumper hitch, part #E-100, is designed to fit around a 4 inch square tube bumper. I went out to the warehouse and measured the distance from the top of the reciever tube to the bottom of the mounting bolt hole and it is indeed 4 inches.…

The eZ latch of the Demco 50-Degree A-Frame Trailer Coupler w/ Jack Hole and Anchors, eZ-Latch - 2-5/16" Ball - 21K #DM16680-52 is absolutely just as safe as a slide lock coupler. It doesn't use a pin but still exceeds the SAE J684 safety…

For an I-beam frame trailer I have a better solution than the #UF35-946403 that you referenced. Instead you would want the part #13703. I attached a picture that I took from that attached install instructions that shows how it would install on an…

The Curt Multipurpose Ball Mount part #D210 measures 5" from the center of the ball mount hitch pin hole to the back edge of the receiver tube opening. The Draw-Tite Max-Frame Trailer Hitch Receiver part #75673 while installed on a 2017 Subaru…

I do have an option for you but none of the bumper hitches like the Stromberg Carlson Hitch Receiver for RV Bumpers part #BA-100 we offer will work with a 3" x 3" bumper/frame, you'd need to get different bolts and fill the extra gap so…

The Furrion Chill AC units like the part #FR42PV are considered to be the nicest RV AC units you can get as they blow the coldest air, are among the quietest, and are very reliable as well. So I would recommend this over a Dometic.

In order to install a Fulton Fold-Away Coupler Hinge Kit like part #FHDPB230101 on a trailer with surge brakes you are going to want to use a flexible brake line that runs from the actuator to the t-fitting just before it splits to each braking…

The Fulton Fold-Away Coupler Hinge Kit #FHDPB230101 is designed for trailers with a straight 2 x 3-inch tongue that is made of steel with a wall thickness of between 0.188 and 0.120-inches. Please note that it is not suitable for aluminum trailers.…

The Stromberg Carlson 2" Motor Home Hitch Receiver for 4-1/2" x 4" Bumpers - 200 lbs #BA-100 will work well for your 4-1/4 inch square bumper. The mounting holes are 5 inches on center and the holes are 1/2 inch, so it will work with…

On your wheel, the 2040 lb indicates that this wheel by itself is rated for 2,040 pounds. So for 2 of them on 1 axle, they have a capacity of 4,080 pounds or whatever the axle capacity is, whichever is lower. If you have a set of the same wheel then…

The Hitch-It 2 Bike Rack for Straight Tongue Trailers #LC731138 comes just as pictured with the arms that hold the two bikes and the trailer tongue adapter to attach the arms to the trailer tongue.

I'm sorry to hear about the interference! I believe you are talking about the Hitch-It 2 Bike Rack for Straight Tongue Trailers #LC731138. This rack comes with clamps that work with 2" - 4" wide trailer tongues. If you are looking for…