Converting a European 7-Way on a 1996 Land Rover Discovery to Work with a US 6-Way
Question:
Hello, I need help figuring out which item I need concerning an adapter for my Land Rover Discovery 1. It currently has a Hella 7 way European I need to connect it to my horse trailer that has a 6 pin trailer end What adapter do I need?
asked by: Myrna D
Expert Reply:
There is no adapter to go from a European 7-Way to a US style 6-Way. You will either have to convert the connector on the vehicle or the one on the trailer. It all depends on what works best for you.
If you only tow the one trailer then converting the vehicle makes more sense. But if you tow other trailers that need the European 7-Way then converting the trailer makes more sense.
To convert the vehicle you will need a vehicle side 6-Way, # PK11609, and you will also need a special converter # RM-732. The issue is that European 7-Way trailer connectors have separate functions for all the lights. US trailers use combined brake lights and turn signals and the running lights are all on the same circuit.
What you will do is remove the European 7-Way. Then use a circuit tester such as # PTW2992 to determine the functions of the wires. Attach the left turn signal wire to the yellow input wire on converter # RM-732. Attach the right turn signal wire to the green input wire on the converter. And the brake light wire attaches to the input red wire.
The running light wire(s) will bypass the converter. Then you will wire in the output wires to the new vehicle side 6-Way to match what the trailer requires.
Products Referenced in This Question
Pollak 6-Pole, Round Pin, Trailer Wiring Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 6 Round
- Pollak
more information >
Roadmaster Brite-Lite Wiring Converter
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal
- Roadmaster
more information >
Product Page this Question was Asked From
Pollak 6-Pole, Round Pin, Trailer Wiring Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 6 Round
- Pollak
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Master Cylinder And Shock For UFP A-60 / A-75 / XR-84 Surge Brake Actuators
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Q&A: Does B and W Gooseneck Hitch # BWGNRK1217 Fit 2017 Nissan Titan XD Long Bed
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can Sway Control Be Used on a Trailer that Uses a Pintle Hitch Set Up
- Q&A: Replacement Landing Gear Motor for Venture M-9000-PK Motor and Replacement Aluminum Gearbox
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Q&A: Replacement Studs for RVD-H-865 7k Hub/Drum
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Can You Flat Tow a Ford Ranger