Troubleshooting 4-Pole Factory Wiring Harness on 2008 Toyota Highlander
Question:
I have attached the pics of my system. It already has a tow-package installed, I thought, but I do not believe that it has a converter. the left light on a trailer stays on all the time. No turn signal, No brake. On all the time on the left side. Please advise, as I already have the flat 4 to square 4 connector on the vehicle. Thank you.
asked by: Wiley W
Expert Reply:
If your trailer lights just recently started malfunctioning, I recommend that you start by checking to make sure that you don't have a blown fuse or a bad relay in your 2008 Toyota Highlander. You will want to check all of the fuses and relays that relate to the tow package.
If all fuses and relays check out to be fine, I would then check the grounds on both the Highlander and your trailer. You will want to check to make sure that the ground wire is secured tightly to a clean metal surface that is free of dirt and corrosion. Each tail light assembly at the back of the trailer must also have a ground. These are most commonly grounded to the trailer frame or through the bolts of the tail lamp assembly.
If you find that all of the grounds check out to be fine and the lights on your trailer still aren't functioning properly, please feel free to email me and I would be happy to provide you with additional suggestions to try and locate the issue.
I have also attached a help article which covers some additional troubleshooting steps for wiring installations that you may want to take a look at.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Trailer Hitch
- Shop: Mounting Bracket 4-Pole Flat
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2019 Toyota Highlander C56217
- Video: Hopkins Custom Fit Vehicle Wiring - Trailer Hitch Wiring - HM11141845 Review
- Video: Hopkins Plug-In Simple Vehicle Wiring Harness Installation - 2019 Toyota Highlander
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Brake Controller
- Q&A: Troubleshootin the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Video: Hopkins Custom Fit Vehicle Wiring - Trailer Hitch Wiring - HM11141825 Review
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob
- Q&A: Where are Connection Points to Install Curt Wiring Harness part # C56217 on 2014 Toyota Highlander
- Q&A: Location of Trailer Connector on 2014 Toyota Highlander with Tow Prep Package
- Q&A: Why Would Mounting Holes of Curt Hitch 13534 Not Line Up Perfectly with 2013 Toyota Highlander
- Q&A: Troubleshooting Low Voltage at Running Lights Pin with Curt Harness on Toyota Highlander
- Q&A: Trailer Wiring Harness for a 2015 Toyota Highlander without Factory Tow Package
- Q&A: Troubleshooting Wiring Harness with 0.5 Volts Between Ground Pin and Other Pins
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Redarc Tow-Pro Liberty Brake Controller Installation - 2019 Toyota Highlander
- Video: Review of Curt Custom Fit Vehicle Wiring - Trailer Hitch Wiring - C56217
- Shop: Roof Rack
- Shop: Side Window Vents
- Search Results: c56217
- Search Results: 56083
- Article: Troubleshooting 4 and 5-Way Wiring Installations