Trailer Wiring Installation on a 2001Mazda MPV
Question:
how to hook up trailer lights on 2001 mpv and where the accessis to the right tail light
asked by: lon
Expert Reply:
The Curt Circuit Protected T-Connector Vehicle Wiring Harness - for Mazda MPV, item # 56010, will be installed inline with the connectors at the rear of the vehicle tail lights. On the drivers side and the passengers side you will need to remove the push pins, trim panels, cargo hooks and jack cover to access the tail light wiring. Once the wiring is located you will just have to disconnect the connectors, making sure not to break the locking tabs, and plug the new harness into the existing connectors.
I have posted a link to instructions for you to review below.
Products Referenced in This Question
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: Trailer Hitch Recommendation for a 2005 Mazda MPV Van
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: How to Pick Out Replacement Grease Caps for a Trailer Hub
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Q&A: Installation Process for Curt Trailer Wiring Harness # 56010 in 2004 Mazda MPV Van
- Article: Towing a Trailer? Let's Talk About Brake Controllers