Troubleshooting A Roadmaster Base Plate Kit Not Aligning Properly on a 2003 Honda Civic
Question:
holes dont alighn close enough
asked by: George
0
Expert Reply:
Without knowing what holes you are having a problem aligning it's hard for me to say exactly what could be going on. Was your 2003 Honda Civic in a front-end accident at one point? That could cause the mounting holes to be off if the damage wasn't fixed properly. Is the alignment problems you are seeing on both sides of the kit? Or just one side?
Do you have an SI model? If so, you would have needed the Roadmaster Base Plate Kit part # 1547-1 instead.
Check out the install video I attached for this base plate kit as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Roadmaster EZ Base Plate Kit - Removable Arms
- Base Plates
- Removable Drawbars
- Twist Lock Attachment
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Q&A: Can a 2013 Honda Fit Be Flat Towed
- Q&A: Recommended Flat Towing Set Up for a 2023 GMC Canyon Denali
- Q&A: Can a 2020 Chevy Sonic RS Be Flat-Towed
- Article: Can You Flat Tow a Ford Escape?
- Q&A: Roadmaster Stowmaster 5000 Tow Bar Compatibility with Roadmaster Base Plates
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012
- Q&A: Parts Interchangability for a Roadmaster Base Plate Kit on My 2009 Honda Fit
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Recommendation of Base Plate Kit and Tow Bar for 2009 Honda Fit
- Q&A: How Far Does Cable of Lippert Components RV Spare Tire Carrier # LC159041 Hang From Surface
- Article: Flat Towing Package for 2016-2018 Ford Focus
- Article: Must-Have Flat Towing Components
- Article: Trailer Wiring Diagrams