Does Dutton-Lainson Hand Winch # DL14825 Have a Brake to Hold the Load

Question

Question:

Is there a stop or catch to hold the load in a certain position?

asked by: Bruce B

0

Expert Reply:

The particular Dutton-Lainson Hand Winch # DL14825 that you referenced does not include a brake or hold function. For this you will want a brake winch.

The linked article on hand winches will give you great background on the types offered and suitability for any given type of application, including brake winches. The link provided will take you to our main page for all brake winches such as the Dutton-Lainson Brake Winch # DL15721 rated for 2500-lbs.

expert reply by: Adam R

0

Answer 1

The size winch that you will need depends on a couple of different factors. I have included part of our hand winch FAQ below regarding boat winches and have linked the FAQ article for you to view. Finding the Right Capacity Winch for your Boat…

view full answer...

Answer 2

On Dexter 12" Nev-R-Adjust Electric Brake Assembly #23-458 the shoe pad thickness is 3/16 of an inch. Dexter says that you should replace the shoes if the material gets down to 1/16 of an inch thick or less.

view full answer...

Answer 3

Because I don't know how your specific trailer is designed with the scissor lift I don't know if the Dutton-Lainson Hand Winch w/ Automatic Brake - TUFFPLATE Finish - 2,500 lbs #DL15721 will be large enough capacity to safely lift your 2,800…

view full answer...

Answer 4

If the outside width of hanger #E4139 is 2-5/16 inches and the metal thickness is 3/16 of an inch then you would take 2-5/16 and subtract 3/16, and then subtract another 3/16, to get 1-15/16 inches. It is meant to be used with leaf springs that are…

view full answer...

Answer 5

You are going to want either our Bearing Kit #BK2-100 or the Timken Kit #TMK52VR. Both of these kits will give you the inner/outer bearings and races along with a grease seal and cotter pin/D-washer for one hub. You always want to replace the race…

view full answer...

Answer 6

We have some very similar winches to the Shelby 5466 that you have but we do not carry Shelby winches any longer. The Shelby is a 2 speed winch with a 2,300 lb capacity so for a very similar winch we have the Dutton Lainson 2 speed winch part…

view full answer...

Answer 7

The Ford Q-206 document is one that we hare very familiar with since it shows the nearly inaccessible location of the brake controller port! For the 2006 Ford F-53 chassis you should be able to use harness #3035-P to plug in a P3 brake controller…

view full answer...

Does Dutton-Lainson Hand Winch # DL14825 Have a Brake to Hold the Load

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching