Was the Tonneau Cover in the Product Pics of the DeeZee Truck Tank part # DZ91752X able to Close

Question

Question:

In the picture shows a tonneau cover, can he cover the bed/toolbox? Is the fill cap too high?

asked by: Ken

1

Helpful Expert Reply:

In the product pictures for the DeeZee Truck Tank part # DZ91752X the lid of the tank was pretty close to the bottom of the tonneau cover but it was able to be unrolled and cover the truck bed.

I attached a set of installation instructions for this tank for you to check out as well.

expert reply by: Jameson C

1

Answer 1

I spoke with my contact at DeeZee and the cap of the DeeZee Truck Bed Auxiliary Tank #DZ91752X that you referenced starts to vent at 4 psi. I also showed them the picture you sent in and they said they weren't able to give directions on how it…

view full answer...

Answer 2

The reason that the valve on the Connector Kit #DZ97962 would need to be closed with the Auxiliary Tank #DZ91752X installed on your 2016 Ram 2500 is because DeeZee didn't design it to work that way and it may cause check engine alarms to go off.…

view full answer...

Answer 3

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 4

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 5

Hey Dave, so the best option for carrying your carbon frame bike and e-bike is the Swagman Escapee part #S39SR with the ramp #S59SR . It has the capacity for carrying an e-bike, is rated for travel trailer use, only touches the bikes by the tires…

view full answer...

Answer 6

Yes, you can install a Curt Trailer Hitch Receiver #C11433 on your 2019 Chevrolet Spark. This receiver is capable of supporting up to 200lbs of tongue weight. With each of the Lectric 3.0 e-bikes weighing roughly 60lbs without the battery you will…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

As long as the flat tow wiring is wired in before the 4-Way #C93ZV and you connect the power for the converter directly to the battery it will work. I have seen several use Magnetic Lights #TL21RK which they will wire in on the main harness to have…

view full answer...

Answer 9

Hey John, so the correct amount of spring bar tension will be based on the trailer's tongue weight and how it affects the suspension of your Nissan Frontier. Every WD system is a little different but what it comes down to typically is measuring…

view full answer...

Answer 10

At the rear of a trailer or RV the ride quality is very rough when compared to the ride quality at the rear of a passenger vehicle. Reason being the suspension isn't as sophisticated and there is a longer distance between the rear axle and the…

view full answer...

Answer 11

Yes, the best option we can offer you to add fuel capacity is with the DeeZee Truck Bed Auxiliary Tank part #DZ91752X which should fit in the space you have between the cab and 5th wheel hitch no problem as it is only 9" deep. I don't have…

view full answer...

Answer 12

The Hollywood Racks RV Rider #HLY64FR has a frame clamp design that was intended for use with step through style bike frame like what your Aventon Adventure bikes have so this rack would work perfect for you. I attached a picture that shows this…

view full answer...