Distance from Hub Face Surface to Edge of Rim and Tire on Kenda 215/60-8 Bias Trailer Tire # AM3H323
Question:
what is the distance from lug holes to back side of rim or tire , need to for clearance issues,thanks
asked by: Robert
0
Expert Reply:
I pulled a sample of this tire from our warehouse to take the measurements you need.
From the rear rim surface that contacts the hub (near the bolt holes) to the innermost edge of the rim the distance is 4-inches. From that same point to the innermost edge of the tire the distance is 4-1/2-inches.
The dimensions are noted on the linked photo.
expert reply by:
Adam R
0
click to enlarge
Product Page this Question was Asked From
Kenda 215/60-8 Bias Trailer Tire with 8" White Wheel - 5 on 4-1/2 - Load Range D
- Trailer Tires and Wheels
- Tire with Wheel
- Bias Ply Tire
- Load Range D
- 215/60-8
- 8 Inch
- M - 81 mph
- 5 on 4-1/2 Inch
- Steel Wheels - Powder Coat
- Kenda
more information >
Continue Researching
- Shop: Kenda 215/60-8 Bias Trailer Tire with 8" White Wheel - 5 on 4-1/2 - Load Range D
- Shop: Kenda 205/65-10 Bias Trailer Tire with 10" Galvanized Wheel - 5 on 4-1/2 - Load Range C
- Q&A: What is the Pilot Diameter on a Wheel
- Video: Kenda Tires and Wheels - Tire with Wheel - AM3H323 Review
- Article: Trailer Tire Sizing
- Q&A: Tire and Wheel Size to Replace 18.5x8.5-8 on Trailer
- Q&A: Smaller Trailer Tire Than 215/75R14 w/ 5 on 4-1/2" Bolt Pattern To FIt in Garage
- Article: Most Popular Wheel Bearings
- Q&A: Is Trailer Tire Size 18.5 x 8.5 x 8 the Same as Trailer Tire Size 215/60-8
- Q&A: Comparing 215/60-8 Tires to 18.5/8.5-8 Tires for Height and Width
- Q&A: What is the Difference Between Load Range C and D ST175/80D13 Trailer Tires
- Q&A: What is the Difference Between Load Range B and C Trailer Tires
- Article: Trailer Wiring Diagrams
- Article: Double-Eye Trailer Suspension System Review
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Measuring a Trailer Tire
- Article: How to Measure Your Trailer Wheel Bolt Pattern
Aaron
2/21/2024
are these the same measurements on the inside towards the axle?