Dimensions Of Mounting Holes On Kodiak Brake Disc Kit # K2R35D
Question:
What is the distance between mounting holes
asked by: Len
0
Expert Reply:
I went to our warehouse and pulled one of the Kodiak Disc Brake Kits, part # K2R35D. I took some measurements and noted them on the attached photo you can check out. The mounting holes at the top of the bracket measure 6 inches center to center.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 10" Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Trailer Brakes
- Disc Brakes
- Marine Grade
- 5 on 4-1/2 Inch
- Rotor
- 3500 lbs Axle
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Kodiak
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Recommended Disc Brake System for Salt Water Boat Trailer with Tandem Axles
- Q&A: Parts Needed to Convert Dexter A-60 Drum Brake Actuator to Disc
- Q&A: Inside and Outside Diameter of Slip On Rotors Included With Kodiak K2R35D Trailer Disc Brake Kit
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Replacement Calipers for TDE 46304 on 2012 Tandem Axle Boat Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Will The DeeMaxx Disc Brake Caliper Work as a Replacement With Tie Down Disc Brakes?
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Q&A: Determining If Kodiak Disc Brake Kit For 3500lb Axles Fits 2004 Amera Trail Tandem Axle Boat Trailer
- Q&A: Difference Between Kodiak Hub/Rotor Kit and Just Rotor Kit
- Article: Adding Electric Over Hydraulic Disc Brakes