Replacement Magnet Clip Recommendation for a Dexter Electric Brake Assembly

Question

Question:

I would like to find a magnet clip that holds the magnet to the brake assembly. It is a Dexter K71-376-00 12 1/4 by 3 3/8 Electric assembly...Thank you

asked by: Fred H

0

Expert Reply:

You will need the Replacement Magnet Clips for Electric Brake Assemblies # BP19005.

expert reply by: Jameson C

0

Answer 1

Actually on brake magnets for trailers either wire can be used as the power or the ground so the colors don't really mean anything. Most likely the magnet manufacturer just put what ever color was most convenient on your trailer.

view full answer...

Answer 2

Dexter recommends that you check the wires of the brake assemblies of your trailer to determine which magnet would be what you would need. If the wires are white you would need part #BP01-265 and if they are yellow part #BP01-301. However, aside…

view full answer...

Answer 3

It is hard to say exactly why the magnet clips of your car hauler keep breaking. If the problem is only on one assembly I would be inclined to believe that the problem is the actuating arm of the assembly or that you are using the wrong clips. I…

view full answer...

Answer 4

Yes, for a 10k rated Dexter brake assembly magnet you would want the part #BP01-301.

view full answer...

Answer 5

Brake magnets for 12 inch brake assemblies should have an ohms reading that falls within the range of 3.0 to 3.8. The 3.7 ohms reading on your brake magnets does not indicate that the brake magnets need to be replaced. If you are experiencing…

view full answer...

Answer 6

Due to the age of your 2006 Big Tex gooseneck trailer the kit you need to convert your axle to disc brakes is the part #K2R1058D11HD since this kit fits Dexter axles made prior to 2009. Then for an actuator kit the best option is the part…

view full answer...

Answer 7

Yes, the part you mentioned is indeed an electric brake assembly, the 10,000 lb self-adjust Dexter brake assembly. That is the left hand side (driver's side), and the following are the part numbers for the left and right side assemblies: -…

view full answer...

Answer 8

I have attached a diagram that shows the pin designations for the 7-Pole Round to 7-Pole Flat Trailer Connector Adapter, #HM47425. I labeled the pins as they relate to the RV side 7-way blade connector. The 7-way round pin connectors typically have…

view full answer...

Answer 9

We have the Trailer Brake Magnet #BP01-265 which is compatible with 12" x 2-1/2" trailer brakes like you have on your 8,000LB axle.

view full answer...

Answer 10

I would check the magnets for wear before going on to test them with a meter. If the magnets show abnormal wear or if you can see the windings beginning to show through the friction surface of the magnet then they will need to be replaced. To…

view full answer...

Answer 11

The correct Dexter Hydraulic Drum Brake Kit for your Dexter 12K Axle is part #23-408-409. The Dexter Hydraulic Drum Brake Kit part #23-406-407 that you referenced is for Dexter 15K Axles and will not work for you. The Dexter Hydraulic Drum Brake…

view full answer...

Answer 12

If you are experiencing poor performance from your trailer brakes you should check a few things to make sure your brakes are performing at their potential. There are not magnets that are more powerful that you could replace yours with to give you…

view full answer...

Replacement Magnet Clip Recommendation for a Dexter Electric Brake Assembly

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching