Hitch Recommendation for a 1999 Ford Windstar Towing a Aluminum Boat and Trailer
Question:
Will this hitch an van be able to pull a 16 foot lund aluminum boat? Also i have rear heat an ac, the hoses look like they would be in the way. ty for your time
asked by: Kelly
Expert Reply:
The Curt Trailer Hitch Receiver part # 13085 that you referenced has been confirmed to fit your 1999 Ford Windstar. It will work and be compatible with the rear heat and AC lines that are present at the rear of your vehicle.
This hitch has towing capacities of 4,000 lbs total trailer weight and 400 lbs tongue weight. If the weight of your boat and trailer are under these figures then this hitch would have the capacity needed.
I wasn't able to determine the towing capacities for your vehicle, but if you consult your owner's manual you should see those figures listed. You should note that the lower of the two figures between the hitch and your vehicle will be the overall towing capacity. The reason for this is that you are only as strong as the weakest component in your setup.
For trailer wiring you would want the Tow Ready Wiring harness part # HM40615.
The ball mount kit # EBMK4 will complete your towing setup.
Products Referenced in This Question
etrailer 2-3/4" Rise or 4" Drop Ball Mount Kit - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- 1-7/8 Inch Ball
- 2 Inch Ball
- Two Balls
- Steel Ball
- Steel Shank - Gloss Black
- Drop - 4 Inch
- Rise - 3 Inch
- Fits 2 Inch Hitch
- 6000 lbs GTW
- Class III
- Ball Mount Kit
- etrailer
more information >
Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Hopkins
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can TorkLift Lock and Load Maximum Security Cargo Tray # TLA7752 be Used in Travel Trailer Hitch
- Q&A: Way to Lock Generator to Trailer Hitch of RV
- Q&A: Fascia Trimming Required to Install EcoHitch on 2016 VW Tiguan
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: Original Wheel & Tire Sizes Supplied on ShoreLandr Trailer Model B16750-12
- Q&A: How to Determine Correct Ball Mount Rise or Drop for Towing a Trailer with a 17 Inch Coupler Height
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Does the Draw-Tite Ball Mount DT49MR Come With Hitch Ball
- Q&A: Bolts Used to Install Curt Class III 13591 Hitch on 2017 Chevy Equinox
- Article: Rust Prevention
- Article: Which Hitches are Made in the USA
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV