Troubleshooting Tekonsha Voyager 9030 and Install Harness part # 3020-P Install on a 2004 Dodge Ram

Question:

Hi Im trien to hook this up to my 2004 dodge ram that has the factory 4 and 7 plug hitch so I have the wiring harness that plugs under dash. Its all hooked up but still no power to brakes???Any help would be appreciated Thank You.

asked by: Harry

Expert Reply:

The installation should be complete for your Tekonsha Voyager part # 39510 with the Install Harness part # 3020-P. The fact that the controller is not seeing power means either the connectors aren't seated all the way or you have some fuses that are blown and need to be replaced.

The brake controller could be bad as well. You could try using jumper wires from your vehicle battery to put 12 volts on the positive side of the battery and ground the white wire to see if it comes on.

I also attached an FAQ on troubleshooting brake controller installs for you to check out.

expert reply by: Jameson C