How is the 4-Way Accessed of Curt Trailer Wiring When Installed on a 2005 Chevy Equinox
Question:
I hooked it up but how do I get the wires outside the vehicle? Do I just hang it out the back and shut the door on it? theres no more directions on this and its not really mentioned anywhere. Thanks, Chevy Equinox 2005
asked by: Dean S
Expert Reply:
Yes, to use the 4-way of the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C55560 on your 2006 Chevy Equinox you will open your rear cargo door, pull the 4-way out, and then shut the door on the wires. Don't worry, the wires will not get pinched or damaged.
An advantage to storing in the vehicle when not in use is that it stays protected from the elements and weather while not in use.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Hitch Recommendation for 2007 Chevy Equinox
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Article: Trailer Hitch Receiver Sizes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 2023 Best Gifts for Auto Enthusiasts
- Article: How to Choose the Right Trailer Hitch Class
- Article: How Much Trailer Can I Really Tow
- Q&A: Weight Distribution Recommendation for 2005 Chevy Equinox
- Q&A: Torque Specs for 1-7/8-Inch Hitch Balls with 3/4-Inch and 1-Inch Shanks