Availability Of 2" Hitch Receiver For A 1991 Mitsubishi Montero
Question:
Do you have a 2” receiver hitch for a 91 montero? I see you have the 1 1/4. I need a 2”
asked by: Rickey R
0
Expert Reply:
Hello Rickey. The Curt Class 2 Hitch # C12181 is currently the only custom fit aftermarket hitch available for the 1991 Mitsubishi Montero and it uses a 1-1/4" receiver. The only way to add a 2" receiver to this vehicle would be to use a universal weld-on hitch such as the Curt # C99CR. This would need to be taken to a professional to have the weld/fabricate something to fit.
expert reply by:
Jesse M
0
Products Referenced in This Question
Curt Class 5 Universal Weld-on Hitch w/ Brackets - 2" Receiver - 44" Wide
- Heavy Duty Receiver Hitch
- Weld-On
- 18 - 44 Inch Wide
- 1600 lbs TW
- 16000 lbs GTW
- Class V
- 2 Inch Hitch
- 18 Inch Drop
- CURT
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class II
- 300 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What is the Standard Bolt Pattern for Pintle Hooks
- Q&A: Hitch Recommendation for a Ford Truck with a Rear Lift Gate
- Q&A: Could Buyers Products Hitch Plate Chevy/GMC # 3371809065 Fit 2009 Chevy Silverado with Dump Bed
- Q&A: What Trailer Tire Size Can Replace A 195/70R14 Tire Size
- Q&A: What is the Difference Between The 2-1/2 Inch Pintle and a 3 Inch Pintle
- Q&A: Recommended Trailer Hitch for a Isuzu Box Truck
- Q&A: Typical Trailer Lug Nut Diameter and Thread Pitch
- Article: Trailer Wiring Diagrams
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Measure for Motorhome Steps
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Trailer Jacks
- Article: How to Measure Your Trailer Wheel Bolt Pattern