Toubleshooting Exterior Sensor Fault on Lippert Ground Control 3.0 Leveling System
Question:
2020 Cherokee Artic Wolf electric lippert leveling system continues to give me a exterior sensor fault. We reset system, but the error keeps coming back. Battery is full, and we are plugged to shore.
asked by: Frank
0
Expert Reply:
It sounds like you are getting the External Sensor Error which indicates a bad connection or wiring from the controller to the sensor. Check the connection on the sensor to ensure the wiring isn't damaged or disconnected. You may need to replace your wiring harness or the Auto Level Remote Rear Sensor on your # LC675817.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Hole To Hole Dimensions For Replacement I-Beam Jack Bracket # LC349975
- Q&A: Solutions To Add More Clearance For Lippert Ground Control 3.0 Jack Legs
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Wiring Diagram and Fuse Location for the Lippert Ground Control 3.0 4-Point Leveling System
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Article: The Best 5th Wheel Hitches
- Article: No Missteps Here: Best Camper and RV Steps (2022)
- Article: Best 2020 Heavy Duty Trucks for Towing a 5th Wheel
- Article: Trailer Maintenance Schedule
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs