Wiring In Lights And A Battery Charger For A Horse Trailer Tac Room
Question:
I have a horse trailer that has a tac room. I would like to add a battery and 12v lights to the tac room. I would like the battery to be charged from the trucks 7pin RV connector, plus a small battery charger to keep the battery charged when not connected to the truck. Do you have the products and a wiring schematic for this type of installation.
asked by: Steven S
Expert Reply:
Hi Steven,
To trickle charge from the 7-way you can just run a 12AWG line from the 12v accessory wire in the 7-way/junction box to the battery. From there you can install a small charger like the NOCO Genius Smart Battery Charger # 329-GENIUS2D. This charger can plug into an outlet and will provide a small 2 amp charge for the battery and is recommended for batteries rated up to 40 amp-hours. You can go bigger but if you're just powering some 12v lights you really shouldn't use much power, especially if you install LED's.
If you go with a larger battery then I'd switch to the Bright Way Smart Charger and Maintainer # 3805212, which can handle batteries from 28 to 250 amp-hours.
If you don't have the lights then I recommend the Opti-Brite 12V/24V LED RV Dome Light # OPT48FR if you don't want to install a separate switch since these have touch sensors to turn the light on/off and adjust the brightness. If you're wanting to use a separate switch then I'd go with the Opti-Brite 12V/24V LED RV Dome Light # OPT98FR instead. I've attached a couple of my videos below to help walk you through this installation. These lights can be ran to a DC distribution panel or just directly to the battery with an inline fuse holder # SWC9538 to help protect the lights.
(click to enlarge)
Products Referenced in This Question
NOCO Genius Smart Battery Charger - AC to DC - 12V - 2 Amp
- Battery Charger
- Battery Charger
- ATV
- Boat
- Car/Truck/SUV
- Generator
- Golf Cart
- Jet Ski
- Lawn Mower
- Motorcycle
- RV/Camper
- Snowmobile
- 40 Ah
- Charges/Maintains
- 12V
- Wall Outlet to Vehicle Battery
- Trickle Charge
- NOCO
more information >
Bright Way Smart Charger and Maintainer - 12V - 7.5 Amp
- Battery Charger
- Battery Charger
- ATV
- Boat
- Car/Truck/SUV
- RV/Camper
- Trailer
- Charges/Maintains
- AC to DC
- 12V
- Wall Outlet to Vehicle Battery
- Bright Way
more information >
Opti-Brite 12V/24V LED RV Dome Light - Single - 6-3/4" Long - White Housing
- RV Interior Lights
- Dome Light
- Daylight White
- Touch Sensor
- Surface Mount
- LED Light
- 12V
- 24V
- 6-3/4L x 3-15/16W Inch
- White
- Optronics
more information >
Opti-Brite 12V/24V LED RV Dome Light - Single - 6-3/4" Long x 3-15/16" Wide - White Trim
- RV Interior Lights
- Dome Light
- Daylight White
- No Switch
- Surface Mount
- LED Light
- 12V
- 24V
- 6-3/4L x 3-15/16W Inch
- White
- Optronics
more information >
Spectro 14-Gauge ATO-ATC Fuse Holder - Qty 1
- Accessories and Parts
- Trailer Wiring
- Wiring
- Fuse Holder
- Spectro
more information >
Product Page this Question was Asked From
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Adding a Battery on an Enclosed Trailer to Power Interior Lights
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Is There A Picture Of This KE33JR So I Can See Exactly What It Looks Like
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Recommended Parts to Rewire an Old Trailer w/ Brakes
- Q&A: Do You Cut Tabs on Both Stacked SeeLevel Sensors SE88VR
- Q&A: Dimensions for Buyers Product Wiring Junction Box # 3375601101
- Q&A: How to Establish Ground Connection When Re-Wiring Aluminum Trailer
- Q&A: What Are the Torque Specs for Trailer Suspension Parts
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)