Is Spindle Washer Needed for 2k Axle

Question:

Do all hub assemblies have an outer washer i e lays between the bearing and cotter pin? I am replacing the original hubs with AKIHUB-440-2-G-EZ-1K. I was under the impression they do require a washer. I thought it must have been overlooked during the original build on that one side. Upon closer examination, the flat washer was missing on both sides of the trailer. I purchased washers locally and can make them fit however the tire does not free wheel as it should. What is best advice in this situation. Thanks in advance.

asked by: Brian

Expert Reply:

Many smaller spindles do not require a washer. Your 1" spindle on your 2k axle falls under this category. It would be great if you could add one like the # SW1000 but since it sounds like it doesn't fit you will have to continue to go without just like you did before.

expert reply by: Robin H