Ladder Rack Compatible With Tonneau Cover for 2024 Toyota Tundra

Question

Question:

Vehicle: 2024 Tundra Crewmax with 5’-7” bed. What do you have that provides a ladder rack that will accommodate a hard tonneau cover? Thanks!

asked by: Gene

0

Expert Reply:

At this time there is only one ladder rack that is compatible with a tonneau cover for your 2024 Toyota Tundra. The rack is the Yakima OverHaul HD Adjustable Truck Bed Ladder Rack # Y01151-5955. However, this does depend on the tonneau cover you have on your truck. It will work with a Retrax XR like the # RTX99XR, Pace Edwards UltraGroove, or Ford Embark LS tonneau covers.

expert reply by: Robin H

0

Answer 1

The clamps on the Thule TracRac TracVan Van Ladder Rack - 2 Bar - 500 lbs, part #TH29055XT, are not rubberized. In order to reduce the opportunity for your 2013 Van to be scratched by this ladder rack you would have to make sure the rain gutters are…

view full answer...

Answer 2

The Thule Telescoping Ladder for Vans #TH301404 uses a magnetic mount system. This can be placed in multiple places on your van depending on what point you need to access. As far as a mount to store the ladder this can vary from vehicle to vehicle…

view full answer...

Answer 3

The magnet itself is 3 3/8" wide and the piece that it is on is 4" wide, so you'll need at least 4" of room to mount the Thule Telescoping Ladder for Van #TH301404 on your 2013 Sprinter.

view full answer...

Answer 4

I was able to determine that the Yakima Load Stops part #Y01161 are a fit for the top channel of the Thule ProBar Evo like #TH713600.

view full answer...

Answer 5

We do not have a profile diagram, however the Thule ProBar Evo 69" #TH713600 or 79" #TH713700 are designed to have channels like the aerobars and will fit the same accessories because the channels are the same. The biggest benefit to the…

view full answer...

Answer 6

I attached a picture that I took from the instructions for the TracRac #TH29056XT that you referenced that shows the tech tip for the Ford E-150s like what you have. The issue is the shape of the Ford gutter. The strip pushes the J-hook clip far…

view full answer...

Answer 7

Thule currently does not offer any replacement parts for their Telescoping Ladder #TH301404. While we do not offer any similar magnetic mounts we do carry the SeaSucker Vacuum Mount #SS73FR. This mount is capable of 120lbs of pull strength without…

view full answer...

Answer 8

Yes. The base of the Thule Telescoping Ladder for Vans - 9 Steps - 8-1/2' #TH301404 is designed to stay attached to the van, but it can be easily removed if needed since it mounts with heavy duty magnetic pucks. I do recommend removing it when…

view full answer...

Answer 9

I went ahead and brought this to the attention of my contact at Thule. He did confirm that the Thule Telescoping Ladder for Vans - 9 Steps - 8-1/2' #TH301404 can be extended from the top down, but it is not recommended. However, he suggested to…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 12

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Ladder Rack Compatible With Tonneau Cover for 2024 Toyota Tundra

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching